View Full Version : Project Finishing
- use Earlex 5000 HVLP sprayer to spray Rustoleum?
- Best outdoor finish?
- Finisher's color wheel
- Water-base Causing Warpage?
- Antique Oil Problem?
- BLO and handsaw handle
- How Light is Blonde Shellac
- Grain Filling with Shellac
- Removing tung oil finish to restain a project
- Daughters bedroom set refinish...help
- iron stains in oak--paste wood filler
- Need help with botched and blotched finish
- finishing oak with Sherwin Williams Pre-Cat too Glossy
- copper bottomed pans staining tung oil top
- Shellac on Douglas Fir
- Applying finish outdoors under a canopy
- Tinting lacquer due to poorly mixed stain
- Help!
- Need drying rack ideas
- Fixing stain blotches on red oak
- S-L-X Denatured Alcohol for dissolving flakes?
- One Pound Cut of Shellac before Oiling?
- HomeStead Finishing
- Staining to look like walnut
- Best Brush for Shellac
- When using exterior dark paint (low LRV), is it better cedar or cellular PVC
- A burl finishing question
- Wake boards and Water resistant finishes??
- Spraying shellac
- Waterlox finish turning too dark on Sapele Veneer
- How do I apply a topcoat inside of this wine rack and do I really need one?
- Japan Drier
- Urushi and Cashew Lacquer
- Clear Coat ove Oil Based Paint
- Fixing scratches on clear laquer
- Aerodynamics of Spraying
- Spraying Minwax Water Base Oil Modified Polyurethane
- best way to get a matte finish without steel wool
- Certified (FDA/USP Class VI or similar) food/medical safe finishes?
- timbermate
- Tricks to finishing White Birch?
- finish drying very slow
- Filling Small Fissures
- Spraying Satin Deft Brushing Lacquer
- Shellac flake question
- Finish for Quartersawn White oak Beds
- Looking for suggestions
- Please help suggest some exterior clear gloss coat for a wood board painting !
- Using lacquer over BLO on figured Maple and getting some weird issues
- Danish Oil on Marine grade Fir for shed exterior??
- Tall Container Needed
- Urethane Casting Resin as Optically Clear Filler
- Basement Built-Ins Help
- hvlp spray gun cleanup - am I excessive in cleaning?
- Is LVLP worth trying?
- Wipe on Poly beads now that I changed paint stripper brand
- "Breaking edge" on cabinets before staining and finishing
- Exterior stain
- what to do to keep a workpiece dust free after a high gloss polish? ... in a woodshop
- Finishing Corian to a high gloss
- Advice needed for finishing new projects
- What wood and stain is this?
- Waterlox sealer/finish as top coat
- Stain 'bleeding'
- Removing water stains from old pine
- cedar chest
- best way to mask off glass in table top before spraying?
- Which HVLP Sprayer to Get.
- Waterlox "desperation" Question ...
- Danish oil: outlawed in So. California !
- Stain Recommendation
- What does "2 mil" look like when spraying a topcoat?
- Cedar Shower Bench Finish
- Sealing Pores in Sapele with Shellac - What am I doing wrong?
- SMC Rock Star: Scott Holmes
- EM6000 surface area coverage
- Outdoor White Oak finish
- salad bowl finish
- brush/roller White Enamel
- Spray Booth Newbie
- painting a carved sign
- Putting a finish on some thin, walnut boards
- dust from pores in finish
- Looking for a good White Lacquer Sealer and the best method for spraying it
- Repairing scratches in Corian
- What is the best way . . .?
- Speeding up the drying process
- Where to get Target EM6500 tinted?
- Premium Brushes for Varnish - what & where to buy
- Turbinaire HVLP Quick Disconnects?
- Oil for outdoor Eastern Red Cedar
- What happen to the Price of Shellac
- Shellac vs. Poly?
- Faux Antique Finish on Red Oak - Best Method?
- Sheen Streaks in Varnish
- In laid Veneer - bleach spots
- Is there a finishish durable enough to withstand minor movement between laminations.
- Kitchen cabinet finishing using water-based finish
- Waterlox is too shiny.
- Filling the Pores in Padauk
- sale for Fuji system
- Mahogany Exterior Door
- Removing shellac
- Cleaning cair and table
- Best cedar deck finish?
- Best finish for my project?
- Problem with shellac
- What's the difference?
- Advice on Finishing with Paint
- steel wool and paste wax to finish finishing?
- Thinning Epifanes Varnish
- glueing over stain
- Wagner HVLP problem
- Finishing the bottom of the outdoor dining table
- Finishing the underside of a desk
- What brand and type of paint for cabinet door?
- How long can water-borne finish stay in spray gun?
- Shellac Grain Filling Red Oak
- This mahogany is rough stuff !
- sata mini jet 4 hvlp questions.
- Waterfall Bubinga Table Finish
- need to refinnish my kitchen table
- Who's used Gemini Coatings conventional Lacquers?
- Kitchen Doors
- Veneer on damaged particle board !
- Repair for damaged piano finish?
- Can I put WO Poly on top of Watco Danish Oil?
- Am I the only one?
- Help with refinishing heavily carved table???
- Matching Waterlox with a Waterborne Finish
- i am a rank rookie at finishing......
- Time to Refinish My Coffee Table
- Small project finish ideas...
- Wipe on poly issue/question
- Help: making H. maple look like walnut
- Thinning General Arm-R-Seal urethane topcoat that might have dried out a bit?
- Suggestion on painting Kitchen Cabs
- Bubbles in HVLP waterborne finish
- Spray Equipment: Air powered conventional/HVLP vs. Turbine HVLP vs. Airless vs. AAA
- Waterlox & walnut. Keep going, sand, or start over?
- Catalyzed Varnish over Nitrocellulose Lacquer
- Easiest way to pop ray fleck in white oak?
- Brush for cleaning siphon tube?
- Deft Water-Born Clear Wood Finish...
- Shop shelf finishing
- Clearcoat w/ Target em6500 INSIDE cabinets?
- wipe on poly
- wipe on poly
- Help with parawood staining
- A couple finishing questions
- Heating Lacquer to thin (instead of using thinners)
- E85 to dissolve Shellac flakes
- Raising the Grain
- trans tint dye and EM6000
- My Air Compressor Died
- Issues with HF HVLP Gun
- Is Shellac an Effective Barrier for Pressure Treated Wood?
- Random Orbitals No More for Me - Here's why (see pictures)
- Painting Kitchen Cabinets
- Staining Mahogany
- finishing plywood bookcase
- Behlen's dye
- New Air Compressor Arrived
- What's a good wiping stain these days?
- final prep before finish
- Spray finishing in a residential area
- Shellac over a gel stain
- How much EM6000?
- Small project sprayer
- Treat wood with Armorall?
- Solvent Pop with Kremlin 10-14 Airmix (AAA) and conventional lacquer
- spraying Varathane
- Top coating woodmasters tung oil
- Defoaming milk paint?
- Floor refinishing
- Best way to spray mass production
- Minimal requirements to safely spray em6000
- Odd behavior with General F Arm-R-Seal: rippling, shriveling, veins in finish
- Top Coat for a Painted Laminate Dresser
- Anyone use grizzly lvlp spray gun?
- I'm thinking of mounting an OSS in my router table.
- Substitute for Seal-A-Cell? (California)
- finish inside of breadbox
- final rubout of Waterlox question
- Polyeurethane Problems, and rubbing out?
- Best way to apply BIN?
- Un-finishing -- is this my only good option?
- Question about wet sanding w/ finish mixture and filling grain
- Source for 25% Ammonia near Austin, TX
- A hand-rubbed finish - literally
- Measuring viscosity of finish when using turbine
- waterlox & stain question
- Questions about spraying a colored finish on new kitchen cabinets
- My first published article ...
- Questions on Homebrew "Danish Oil" for Cherry Cradle
- New to thread got unique question
- danish oil, gel varnish, or clear poly?
- Best finish for cutting boards
- Shellac Finish - How many coats
- I should have researched first
- Need advice on refinishing coffee/endtables
- oil based primer
- What to do with dresser interior?
- Gluing ebonized red oak.
- Matereal for project to rest on that wont stick to shellac
- Sanding the sheen off polyurethane
- Compressors and Spraying
- Grain filler question
- New guy...
- Cleaning exterior of a spray gun?
- What solvents to keep on hand.
- Arm-R-Seal
- Latest projects and ebonizing revisited
- Shelf Life of Nitrocellulose Lacquer
- HVLP Question
- Got the Earlex 5500 HVLP
- Type of wood to use to paint on and Faux finishes
- Big Mistake
- Dye/Pine
- ?Best Finish for interior veneered doors??
- Portable Paint Booth
- Laser Treatment - finishing a badge
- Citrus Solvents
- Waterborne finishes
- target coatings em2000
- Poly after stain
- what to use to remove a Deft poly finish.
- Need help finishing Zebrawood
- Best Finish for Kitchen Cabinets
- Warning: Store your respirator in a bag ,8 hours of use is the average cartridge life
- How to price a refinish job?
- EM8000 Tinting
- Shellac runs when brushed.
- Staining/Painting/Bleaching Mahogany White?
- Bar top (poured) finish
- Waterlox Satin question - feels rough or textured?
- Target Coatings-Great Customer Service...
- "Deglossing" a finish...
- Finish-safe (removable?) adhesive
- Rut Row Floor refinishing
- Yet another cleaning spray gun question.
- Em6000 Question
- Respirator suggestions for bearded, glasses-wearing person
- Nitrocellulose Lacquer Storage Ideas
- Building painted wainscoting with painted walls. How to get a clean edge???
- Painting toys
- Which Target Coatings products for kitchen finishing
- Matching finish on different woods
- What kind of a sprayer should I get?
- Tinting Shellac or Lacquer,which can give you the widest array of colors?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.