View Full Version : Project Finishing
- What to use to finish cabinet carcasses?
- Which Sandpaper
- How to achieve this look???
- gell stains drying too quickly
- Help, mineral oil streaks under shellac
- Thin visocsity epoxy
- Exterior Door UV protection
- Epoxy/transtint and waterlox
- WB Poly over Oil/Varnish?
- Point Turner finish
- Waterlox re- re- re- redux
- WB 2k poly (conversion varnish)
- Spraying Clear finishes
- 3-m finesse-it
- Question Bout Shellac
- Help! Spar urethanes
- Spraying Kitchen Cabinets
- 3 questions about sanding between coats of varnish
- Cedar-Aromatic and a sticky question
- Vacuum for Removing Sanding Dust
- First timer with Waterlox
- Priming poplar furniture - best product or not at all.
- Curly maple end grain turning grey?
- What rag to wipe waterlox on with
- WAterborne over a different brand waterborne?
- First time finishing walnut using oil (letter organizer)
- Comparitive Testing on EnduroVar, Enduro Clear Poly, Arm-R-Seal, and others
- Priming Plywood : Cure time exterior Latex
- Rubbing out Waterlox Gloss for a glassy look
- how to achieve barnboard look using GF milkpaint and glazing
- Waterlox frustration
- Cleaning an HVLP Sprayer Between Coats
- What kind of paint?
- Tung Oil question....
- Cabinet door finish
- EM6500 finishing problem - any advise?
- Surface prep to finish time frame?
- Cutting BORG Shellac
- Poure / grain filler help
- Please explain how to "tip off" varnish
- Never used trans-tints
- Need advise on spraying with the Fuji mini mite 3
- help with refinishing oak table
- High Gloss Painted Table.
- Redwood tongue and grove paneling
- Kitchen cab refinishing
- Wood lamp type of finish to use?
- Scratches On Walnut Top
- How to avoid glitter finish
- finish to use on wooden counter top that will get beat up.
- Air Compressor and Spray Gun. What's the right combination
- Where did all the cracks come from?
- Finishing supplies
- Tough, yet natural varnish or urethance over shellac on cherry
- Shellac shelf life
- Test boards & stock solutions
- Finishing interior Mahogany doors
- Finishing Cypress
- Rustic looking finish - how?
- How to finish this tripod table base?
- finishing tongue & groove
- Waterlox # of coats
- Primer for Rust-Oleum Oil-Based Enamel?
- Help with shellac / grain filler
- Stain/finish suggestion for a TV stand
- About to paint bare poplar kitchen cabinets
- Cleaning Brushes: Possible or Cruel Hoax?
- After shellak as grain filler
- Baltic or China birch drawer boxes
- Whether to finish the underside of a dresser top?
- Restoring an old Desk
- Wagner Finecoat 2 HVLP Sprayer & Dutch Boy Latex Paint
- Refinishing a Stanley #3 wooden level
- cutting board inlay filler?
- Green lacquer thinner
- Spraying Drawer Fronts
- Buffing out Waterlox High Gloss on dining table
- Finishing Schedule
- Inside Drawer finish .... Shellac or Wax
- Filling wormholes (clearly)
- Poly over CA?
- What kind of stain produces this?
- Gel stain not dry? Now what
- Compounds/Polishes with ROS?
- Best finish that can be cleaned with bleach?
- cutting board filling holes
- need advice - painting oak cabinets
- My chess table keeps coming out glossy. How can I get it satiny?
- Varnish Cure Question--Humidity v. Fresh Air Flow?
- Flooring Finishes
- solar lux behlen dyes
- Most Highly-Respected Solvent Poly Varnish?
- Dying maple... Again
- Mini regulator on a HVLP turbine system
- Make White Oak look like Red Oak?
- Laquer Sanding Sealer? Necessary?
- Questions about choosing & using DYES.
- Chalky Walnut
- Brushing on a "spray only" finish?
- Paint options for cabinets
- spraying shellac and lacquer
- To shellac, or not to shellac? That is the question.
- Minwax Water Based Oil Modified Poly
- Lighter grain on Ash
- Using wax for a top coat?
- What kind of Wax?
- Poly vs Acrylic?
- Rant: Rattle can clogging
- maple night stands
- Clear paste wax over walnut finished with poly
- Finish For a Chest-on-chest Bottom-chest Top
- Shellac flakes only the finest flakes...
- Shellac - Yellow, Black, Kusmi, Dark Jethwa…. ?
- Prevent Oxidation on Steel?
- Target HSF 5000 HIgh Solids Filler
- Problem with walnut
- Garnet Shellac - Does it darken over time?
- How Do I Do This?
- Quick question about rubbing out
- Finish for Pine workbench top
- Last question about Waterlox Original Formula Sealer/Finish
- Applying finish over tearout
- Beech, tannin and ammonia
- Finishing cherry kitchen cabinets and bathroom cabinets
- staining red oak to match old polyurethane
- Steps for finished with dyes
- Pre Finished Drawer Box Material
- Colorful Dyes
- Type of Waterlox
- Preserving pink color of cedar
- Need Help Choosing a Finish For My Hickory Kitchen Table top
- Shellac made with methanol
- Kitchen Cabinets Finish Flaking
- How would you finish this?
- Water stain in unfinished Wenge
- Epifanes rubbed effect varnish and shellac in the shower
- Why is my finish blotchy?
- How to remove dried on electrical tape from an antique
- Casework Interiors
- Questions on Shellac
- Blue Paper Towels
- Watco Teak Oil?
- Need advice on painting a TV cabinet
- Waterlox and mirror finish help?
- Finishing walnut trim
- Refinishing/repairing walnut table
- Matching an Ethan Allen color
- First time using TransTint water based dye
- General Finishes Arm-R-Seal
- How do I 'finish' pre-finished edgebanding?
- Tabletop finishing questions
- Poly over waterlox?
- Help me fix Grandma's Table
- Waterlox/Grain Filler - Starting Over Help
- Osmo Polyx Oil on India Ink
- Laminate or Veneer? Help!
- Storing Wiping Poly
- Finishing schedule for walnut live edge coffee table
- Hard Wax Oil on Kitchen Cabinets
- Penetrating finish that doesn't darken>
- table top
- Buying ML Campbell products
- General Finishes - Orange Oil
- New forum member and new project build
- Sorry Quick Question Without Searching on Red Oak
- Strange Blotching in Finish
- Best pad for buffing wax?
- Finish Recommendation Please
- Saw Dust Bleed
- Using Polyurethane 1 hour after staining.
- Dealing with gray stains in yellow pine
- Rubbed through table top finish
- General finishes gel stain/target coating em6000 compatibility
- Spraying conundrum
- Help with spraying Target Coatings 9000 poly
- Choosing a spray system... overwhelming
- Earlex 5500 users. Are you spraying latex paint?
- Hazy swirls in arm r seal
- Milk paint topcoat?
- Using Mahogany for trim
- Finishing the obligatory live edge slab
- Staining
- EM9000 Problems on live slab
- Finish recommendation for SYP kitchen shelving
- From Great Day to OH @#%& In a Heart Beat
- Help Selecting Paint for Crib
- Paint over Poly?
- Where did all the ethanol go in denatured alcohol?
- Target and General Finishes
- Danish Oil Issue?
- Douglas Fir Exterior Door
- Finishing a white entertainment center + wainscoting/trim
- Help with a quick and easy finish
- Wet Sanding with Mineral Oil
- Help with black/gold over poplar frame
- Praise for Wipe on Poly
- Looking for finishes that are non toxic and don't smell...?
- finishing a walnut/cherry coffee table
- Yahtzee yard dice
- How old is too old?
- Charles Neil's Blotch Control
- Cleaning A Spray Gun
- Finish Wenge for Wall Piece
- Anyone use ML Campbell Aqualente Pigmented Lacquer?
- spalted maple and walnut tableIt is hideous with splotcing I am currently sanding off
- spalted maple and walnut tableIt is hideous with splotcing I am currently sanding off
- Before or After Question
- Cutting board finish clarification
- When A Glass Stop Pin Goes Awry
- Staining Douglas Fir or White Pine to Look Like Cherry Heartwood
- Staining Cedar
- How do you finish Padauk or Bloodwood?
- Anyone using 3M's PPS system or Accuspray gun?
- Finishing question
- Ideas on Fuji's G-XPC Gun
- Paste wax finish near fireplace
- What is a nice finishing product for Spalted Maple? To be used as a bench.
- Nakashima Conoid (Spindle) Bench Glue Up Question - Finish or Glue First
- Pumpkin/Gourd stripped the finish...
- Chestnut Blotch
- Initial Impressions of Qualspray Spray Gun
- Hockey stick table - how to finish?
- Suggestions for finish on Titanic Deck Chair
- Aging pine to look like barnwood
- How long before wax after danish oil?
- What type of finish for table and toy furniture
- Finish for dinning table
- Cutting Board Finish
- Base coat of waterlox or blo
- Finishing a piece one side at a time: Preventing overlap/drip
- How is this finish achieved?
- Spraying deft over arm r seal?
- trouble with finish/stain bleeding to edge of adjacent wood
- cabinet finishing time
- Finishing Drawers - Inside and Out
- Hiding grain
- Spar Urethane on top of Water Based Poly?
- Bathroom vanity finish that looks like raw wood
- Watco wipe on poly?
- Removing Poly from Bark? Can it be done?(Without Sanding)Or darkening current finish?
- So is Waterlox a tung oil finish or varnish?
- GF Enduro-Var over shellac
- Citristrip Stripping Gel???
- American walnut veneer kitchen units suggestions
- Finish for MDO Veneer outfeed table top?
- NC lacquer disappearing into soft redwood :(
- Waterlox Finish Problem
- So What Constitutes that "plasticy " look?
- Painting the edges of Baltic Birch Plyood?
- Maple Bleaching
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.