View Full Version : Project Finishing
- Finishing MDF (9 replies)
- Tone down a finish? (17 replies)
- Question about Clear Poly (4 replies)
- Another Maple & Dye question. (5 replies)
- Ebonize long leaf pine? (1 replies)
- Shellac and BLO (5 replies)
- Plyboo (0 replies)
- clear penetrating epoxy: as good as it sounds? (0 replies)
- Best durable finish for cherry? (1 replies)
- Oil Water Compatibility. (5 replies)
- Rockler HVLP Spray Gun?? (5 replies)
- bar top finish question (3 replies)
- A Glass smooth finish (How do I get) (10 replies)
- Best durable finish for cherry? (3 replies)
- Dealing with SHELLAC RUNS (14 replies)
- Help - many??? (3 replies)
- Smoke damage (2 replies)
- Refinishing bedroom set - question (2 replies)
- HVLP or standard pressure spray (10 replies)
- Interesting statement about finishing (6 replies)
- non-toxic exterior wood sealers (3 replies)
- sauna bench finishes, wax? (8 replies)
- Edge banding (4 replies)
- Finishing oak entertainment center first timer (3 replies)
- Need advice on finish to go over a label (5 replies)
- Homemade exterior wood sealant (5 replies)
- HVLP vrs compressor and HVLP gun (2 replies)
- Dye/Coloring to Bring Up Maple Grain...? (7 replies)
- Furniture refinishing/pricing question (6 replies)
- Painting bookcases (3 replies)
- Easiest finish for workshop cabinets? (31 replies)
- Finishing unmatched boards (2 replies)
- Earlex HVLP Spray Station Pro (17 replies)
- Best Finish for a Unique Piece of Birch (5 replies)
- HVLP Sprayer Question and Dog House (2 replies)
- Waterlox over Watco ? (2 replies)
- Recommendation - Finishing/Refinishing furniture (1 replies)
- Dark wax for dark wood... (9 replies)
- Material Sources west of Phoenix AZ? (2 replies)
- Is McCloskeys gone ? (10 replies)
- Finishing Chairs for Outdoor Use (9 replies)
- shellac over poly (5 replies)
- Cherry Chair last step (4 replies)
- Latex Polyurethene help (21 replies)
- inside the box? (1 replies)
- Natural Edge Finishing (3 replies)
- Senility is catching up!! (3 replies)
- Satin Finish: Favorite? (5 replies)
- Opinions needed on Tea Tray (11 replies)
- Stain/Poly/Etc. Can Sealing (7 replies)
- "Chalky" USL? (2 replies)
- Wipe-on poly over USL? (4 replies)
- Wax over wipe on poly? (1 replies)
- what finish over a photograph. (1 replies)
- "Popping" Quilted Maple (16 replies)
- Lots of exterior paint work to do (3 replies)
- Suggestions for water based mahog finish (11 replies)
- blo (8 replies)
- Newbie: steel wool question (4 replies)
- Can I sand Tung Oil Finish? (5 replies)
- new finishes on Kitchen cabinets (6 replies)
- finishing interior knotty pine (4 replies)
- Proper painted finish for cabinets (21 replies)
- hvlp sprayer (2 replies)
- Small Box Finishing (13 replies)
- Solid Cherry Top Kitchen Table (2 replies)
- System 3 Mirror Coat?? (3 replies)
- Oak finishing disaster help (20 replies)
- Water rings (4 replies)
- S.Maple vs H.Maple (1 replies)
- I have been asked to repair an ark where the veneer is peeling and slipting. (7 replies)
- Finishing Red Oak (1 replies)
- Thined Epoxy (6 replies)
- Apollo 7500T HVLP Gun (5 replies)
- Weird staining issue - need help (9 replies)
- poly over lacquer (8 replies)
- Painting MDF and popular (3 replies)
- Looking for a SF Bay Area Finishing Stripping Company (0 replies)
- Water based lacquer (7 replies)
- Recommendations on Refinishing Books? (5 replies)
- Pine Wood Floor Finishing (19 replies)
- Replicating a modern finish (3 replies)
- desk clock with tung oil (1 replies)
- Filter Material (2 replies)
- Using wood filler with multiple woods (1 replies)
- Problem polishing shellac finish (9 replies)
- Making an Oil Varnish (6 replies)
- Poly/Mineral Spirits Question (3 replies)
- chemical stripper that will raise wood grain a bit? (7 replies)
- Drawer lining (6 replies)
- sycamore - preparation and finishing (2 replies)
- Another maple finishing question (3 replies)
- Paint Removal Festool Questions (10 replies)
- Uneven Surface After Stripping (4 replies)
- Nitrocellulose lacquer and temperature (3 replies)
- 100 yr. table and chairs refinishing (2 replies)
- Finishing wood with high moisture content (8 replies)
- Need Recommendations (5 replies)
- Velvit Oil... a couple questions (2 replies)
- Finishing Cherry (2 replies)
- How many coats? (9 replies)
- Pottery Barn stain matching revisited, possible breakthrough (0 replies)
- Child's bed--should I apply water-based lacquor over shellac? (2 replies)
- Last step in the finishing process? (3 replies)
- Best furniture polish/cleaner? (6 replies)
- Veneering over a finished surface (4 replies)
- white oak Vs Red Oak..... (20 replies)
- Finishing stair treads (9 replies)
- Spray equipment question (1 replies)
- To thin, or not to thin ...? (4 replies)
- Newbie finishing question (3 replies)
- Compressed air filter (4 replies)
- Better Wax (2 replies)
- Newbie Question on Polyurethane (7 replies)
- Behlen Table Top Finish (25 replies)
- Dining room table, shellac mistakes, and breadboard ends... (1 replies)
- Need advise/opinions (1 replies)
- Daly's Benmatte Source (1 replies)
- Home Bar Top (55 replies)
- Help in finishing Beech and Walnut (26 replies)
- Sanding Sealer Help (4 replies)
- Refinishing Prices? (2 replies)
- Sawdust mixed with wood glue or epoxy as filler? (5 replies)
- Drying wood with "Shellac"? (4 replies)
- Using Waterborne Lacquer on Ebonized Oak (14 replies)
- best paint finish for wood toys (3 replies)
- How to make wipe-on Poly (9 replies)
- antique Koa finish? (5 replies)
- Alkyd Varnish vs Arm-R-Seal (1 replies)
- Finish to retain natural wood color? (7 replies)
- Staining Before or After Gluing? (4 replies)
- Cost to Refinish Many Tables? (10 replies)
- Best finish for dining room table (5 replies)
- Briwax original (3 replies)
- What woods stain well? (3 replies)
- Finishing Cherry, How do you do it? (14 replies)
- workbench finish (8 replies)
- Trying to match antique brass hinges (2 replies)
- Will these work? (3 replies)
- Grain/Pore Filler Reccomendation (8 replies)
- Retaining wood color (4 replies)
- Stains that are food safe? (4 replies)
- Paint Sprayer Cleanup and Storage (3 replies)
- LVLP Problem (2 replies)
- Waterlox (23 replies)
- Need help finishing over aniline dye. (2 replies)
- pine or poplar for painted finish? (12 replies)
- Shellac Shelf Life (3 replies)
- Finishing Wenge Veneer (0 replies)
- Need advice (4 replies)
- shellac over aerosol lacquer toner (1 replies)
- Spraying Laquer (6 replies)
- I have different color raw cherry, will it darken the same? (11 replies)
- Suggestions on finishing built-in (5 replies)
- polyurethane woes.. (22 replies)
- Pre-Stain Wood Conditioner Usage (5 replies)
- Rubbing Out Lacquer (2 replies)
- Removing Fingernail Polish from a Table Top (7 replies)
- Refinishing Altar Table (3 replies)
- first project, several questions (14 replies)
- What to do with old Polyurethane? (7 replies)
- Ebonizing alder schedule (1 replies)
- Best finish for kitchen cabinets? (3 replies)
- Problem with dye on maple (4 replies)
- Rubbing Out Varnish (5 replies)
- Dance Floor Finishes (1 replies)
- What would you buy for $150-300? (2 replies)
- Measureing % (4 replies)
- Looking for air brush recomendations (1 replies)
- Bad Shellac? (9 replies)
- Oak and Water Based Aniline Dye (2 replies)
- Lignum Vitae ? (3 replies)
- Gel Stain pros and cons (7 replies)
- Target coatings? (13 replies)
- PaperIllusions Topcoast (6 replies)
- Finish over wax? (1 replies)
- Hand rubbing water based varnish? (1 replies)
- Epoxy Inlay on Paint (5 replies)
- What is the best water based Paint to spray? (3 replies)
- 1st Time Sprayer, need material advice (7 replies)
- Decals on wood (3 replies)
- Advice on finishing hemlock,please!! (3 replies)
- Trying to match Pottery Barn "stain" (4 replies)
- Darkening Walnut (7 replies)
- cloudy polyurethane (0 replies)
- Finish on drawer slides? (2 replies)
- The Ultimate Finish Question? (9 replies)
- Novice at finishing. Some questions (10 replies)
- Oily wood (6 replies)
- Finish for Black Walnut dinning table?? Thinking Watco oil.. (11 replies)
- Spraying GF Arm-R-Seal (4 replies)
- finishing schedule compatibility (3 replies)
- Is Waterlox Sealer necessary under WL Satin? (2 replies)
- spray gun advice (6 replies)
- Hi Gloss Table top? (5 replies)
- A Little Advice, Please... (5 replies)
- Balance Beam Finish (1 replies)
- Spray gun for paint and laquer. (4 replies)
- Using a spray gun in the shop (8 replies)
- help needed-what's your favorite color? (3 replies)
- Tiger Striped Red Oak (11 replies)
- InslX Cabinet Coat (13 replies)
- Advice please (2 replies)
- Excentuating color differences (3 replies)
- brushed gold foil wrap (4 replies)
- Shellac ? (5 replies)
- Oak Ply bookcase suggestions (14 replies)
- Target HybrVar (4 replies)
- Spray/Finish room (8 replies)
- Lye used to darken Cherry (0 replies)
- Color perception after eye surgery (4 replies)
- Quick finish for lacewood (3 replies)
- Watco Danish Oil (21 replies)
- Material Compatability (7 replies)
- Hybrivar on Walnut (7 replies)
- How long till min wax dries enough to clear... (4 replies)
- Dying Pine (2 replies)
- looking for some color... (3 replies)
- Finish woes from a new finisher. long. (2 replies)
- Finishing Cherry (3 replies)
- Water Based Acrylic Color Selection (2 replies)
- Finishing Mahogany and Wenge (3 replies)
- HVLP & conversion varnish (2 replies)
- Ash Ebony Dye - Wrong (5 replies)
- Zinsser poly (1 replies)
- insect damage and finishes (1 replies)
- TransTint Ratios? (7 replies)
- Repairing Stain damage under poly?? (2 replies)
- Finishes described and compared (1 replies)
- Need help soon, re: box finish. (3 replies)
- old school desks (4 replies)
- Overcoating Shellac (2 replies)
- Confusing (5 replies)
- Stupid is as stupid does. (6 replies)
- Another cutting board finish Q..... (3 replies)
- Would appreciate a little help with Waterlox (16 replies)
- doll bed finish? (4 replies)
- Paint thinner & mineral spirits (3 replies)
- Where to find dye or powdered pigments? (2 replies)
- Laquer and oil based glaze (2 replies)
- Have any of you used mixol universal tints? (4 replies)
- Has anyone here used mixol universal tints? (4 replies)
- What's the story with gel stains? (9 replies)
- Penetrol by Flood products (5 replies)
- Waterborne Floor Finishing (3 replies)
- durability: watelox only or shellac overcoat (3 replies)
- Salad Bowl Finish Uneven Looking (5 replies)
- Arm-r-seal not drying/curing......HELP!!! (10 replies)
- Kitchen Cabinet Finishing (1 replies)
- Steinway Piano Finish (22 replies)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.