View Full Version : Project Finishing
- Book ends with sliding bar
- Floor finishing question
- Ebonizing and Gluing
- Re-painting question
- BLO, a continuation
- Blotches with stain on cherry
- How to best remove brush strokes from Waterlox finish
- Liberon Black Bison: Worth the price over Minwax?
- suggestions for matching existing cabinets
- Can Water Based Shellac be used as Top Coat
- Does Varnish smell go away..
- Matching finish of kraftmaid kitchen cabinets
- Name that finish!?
- Black Spots in Maple
- Gel Stain
- Water Based Stain on Plywood Rag Marks
- QSWO baseboard finish??
- Spray Guns
- Dresser and Shellac
- Getting a HVLP system... need advice
- Festool as finish Specialist- Comments?
- Finish for Quartersawn Sycamore
- Paint for new bathroom cabinets
- How Long Does EM6000 Last . . . ?
- Question on finishing schedule
- Finsh help!
- Has anyone used General Fishes Enduro Var on kitchen cabs?
- Painted project
- Wood barely absorbing stain/wrong color
- The parts that you don't see finish
- Frustrations with finish
- Clear top coat on latex acrylic
- The Shellac Shack
- Purchasing and Using Shellac
- Finish for oak on the outside of a vehicle
- Matching new Walnut to Old
- Finish for Box Elder
- top coat both sides or one in a cabinet made with plywood
- Target EM6000
- I have a question but
- Bench Finish
- Polyurethane congealing problem
- Beginner questions for sprayers and a kitchen cabinet finish
- Is
- How to make wood pop / Accentuate grain and Chatoyance with Water-Borne Finish
- EM2000 Waterborne Alkyd Varnish
- shellac over oil stain
- Best finish for exierior oak?
- Graco HVLP 9.5 FinishPro
- Grain filler dither
- Finishing a Mahogany Butcher Block Countertop
- grain filler
- Staining Bamboo plywood
- Kitchen cabinet finishing
- Minwax ?
- Best exterior Ipe table finish
- Setting up to spray solvent-based laquer - need affordable explosion proof fan
- No more Paint Thinner in California
- Finish for a Wood Butcher Block Top
- Grain Raising
- Good substitute for Target Coatings??
- Finishing the Finish with wet sanding shellac. Whats your technique
- Waterlox on Red Oak floors
- Willl Sikkens acrylic over oil-based stain work?
- Problem Making Filler
- WARNING: Linseed oil and rags..
- Van Dyke Brown Glaze
- Painting croquet balls...
- Spraying Enduro Var
- knockdown spray booth ideas
- Amateur Question: Refinishing Inlaid Veneer Surface
- Using EM6000
- Anyone doing Restoration and Refinishing as a pro?
- lacquer
- Crystalac
- Confused - Need Advice - Walnut Farm Table Top Finishes
- General Finishes Enduro-Var is nice, BUT..............
- Adirondack chair finish
- Need some advice on a spray gun....
- First spray finish project
- Finishing Maple
- Chemical Incompatibility with plastics for knock-down spray booth
- Cost effective, water resistant finish?
- Forgot the pre-conditioner! What now?
- Waterlox original sealer finish Question
- Devilbiss
- Tree Bookshelf Finish
- Love my Earlex 5500.
- Fuji, Apollo, Graco, or Titan
- carrier for pigment
- Sanding Varnish: is this a bad sign ?
- Finishing my office - advice needed
- Is it possible to make satin shellac for spraying?
- Finish on jarrah
- Cedar Adirondack Chairs
- What makes a turbine special?
- Finishing Cherry with un-even color due to sunlight
- Harbor Frieght HVLP
- Finish for a reclaimed Cedar
- Don't gloss over this
- What Finish is best for a Cherry Bathroom Vanities
- Varathane Crystal Clear?
- Water based top coats, so many to choose...
- gloves for finishing?
- Standardized finish benchmarks
- Finishing laminated spiral handrail - soft maple
- Polyurethane over cyanoacrylate
- Spray-gun recommendatioons.
- I need paint advice
- shellac questions
- oil base poly over water base glaze
- Shopping for an hvlp system
- How should I finish soft maple
- Topcoat over danish oil
- Airbrush setup basics
- shellac on veneered projects
- Cleaning/finishing old wood (Typesetters trays)...few questions
- Can I eat it?
- I'm having a problem with Strippers . . . Refinishing a Mahogany Bed Frame
- Waterlox and Walnut - Shiny spots
- Staining Beech
- Anyone using minwax wipe on poly as the resin component for an oil / resin finish?
- How to dye black & still see the grain?
- spray poly
- Has anyone tried sodablasting to remove old finish/stain?
- Exterior wood louver doors
- Top coating latex paint and oil based stain
- Chatoyancy / popping grain / blotching
- Finishing Stairs
- How to paint beautiful mahogany shutters dark green - and have it stick.
- Can I rub out / Buff Epiphanes gloss Marine Varnish?
- Sanding between coats with waterlox - with due
- BLO & Shellac
- finish advise
- Door refinish - sorta/not wood
- Latex paint and paint brushes
- Painting commercially finished furniture?
- finish for a walnut/cherry bathroom vanity top
- Looking For a Recommendation For A Liquid Rub Down Wax
- What's the infatuation with polyurethane?
- How do I proceed - Bad Orange Peel on Shellac
- Refinishing kitchen cabinets
- Poly question
- Difficulty Level: Refinishing chairs to match dinning table
- Re-Finishing cabinets
- Yet another finish first question.
- Staining Poplar
- What's the best finish for...?
- S&W ProClassic? Wich one?
- Odd problem with dye
- Thickening agent for oil based paint or polyurethane
- warping wood with latex paint
- Refinishing Dining Suite
- LMI Micro-bead Acrylic Paste Filler
- finish for desk top - shelac?
- Spray Painting on the Cheap
- Source for Gerson spray gun paint liners
- Spray gun questions
- 3M #10 gun vs Fuji XPC?
- Turn exterior stairwell into spray booth?
- Do you put panels vertically or flat for spraying? (EM6000)
- Attractive colorant/finish for birdseye venner?
- What's going wrong?
- Lacquer not drying/gummy
- What type of stain/dye/gel for a large bookshelf/built-in project
- Maximum time between coats on oil/varnish wipe on blend?
- Bad General Finishes Stain?
- SEATTLE: UV Coatings in Seattle Area? Full Time Finisher?
- HVLP Super Flexible Whip Hose--why didn't I do this sooner???
- Questions on P&L #38
- Non-yellowing white water-resistant finish for bathroom wainscoting?
- Flatting agent for water based lacquer
- Hawaiian Finishers
- Drafting Table finally finished
- embedding music sheets in finish
- Spraying - Conversion gun question - or is it me?
- Can someone explain 'rubbing out' a finish?
- Has anyone used Perilla oil?
- Adhesion promoting primer problems on celular PVC. [Azek, Versatech]
- Questions about tinting clear finishes
- Sometimes ignoring advice.......LOL!
- Applied Too Much Wax
- Finishing problem
- Distilled Water as a thinner for Aqualente
- Exterior door finish recommendations
- Cloudy haze, Target Coatings EM1000 sealer
- Refinishing Baby Crib
- High gloss finish on mdf
- Sanding/Sharpening media and their respective grits
- My super fast, super shiny, super glossy, super cheap, super easy one day finish
- Water based poly & white clouds
- White bondo with white catalyst..is there such a thing?
- Finish suggestions for western red cedar rocking horse
- Experimenting tinting epoxy
- Raised Panel MDF finishing
- Considering An Airless Sprayer
- Half mask for Lacquer Spraying
- Help with Transtint
- Different Transtint Question--scalling drops per 4oz to mix a gallon
- Birch Plywood & EM6500... Do I need to use a primer?
- P&L 38 for floors ?
- Jatoba finshing - need help
- How scrupulous must the prime coat be?
- Clear Coat over Acrylic Paint
- Reclaimed wood saturated with some industrial product - question on sealing it in
- Spraying Polyurethane Oil based
- Jatoba finshing - any suggestions?
- Using Sealer Before Stain ?
- DNA-Shellac
- Removing poly from glass
- Touch up spray gun vs airbrush
- refinishing a desk: old masters gel stain dark mahogony over a veneer
- Rosewood Marking Gauge Finish
- Reviving old finish on carved piece?
- How do you keep your spar varnish from spoiling?
- Graco 4900 HVLP
- Stain and topcoat suggestions
- Best HVLP Conversion gun
- Grain filler
- Rub-Out/Polishing Help - Newly Completed Desk
- curly maple and cherry finish questions.
- Transfast Extra Dark Walnut looks reddish - First time dying
- Can I "unthin" latex paint?
- Target EM8000cv
- Deft lacquer - first time user desktop veneer over a gel stain
- Staining Mullions
- building mahagony bar and need finish ideas
- Possible issue with finish
- Finishing spruce like a violin?
- I may need some help.
- Spalted Maple Slab - Does it need stabilization?
- Latex on furniture
- Another Spalted Maple question
- Shellac between transtint and poly?
- Removing chemicals/paint from factory reclaimed Heart Pine
- How should I finish these drawers?
- Water based paint
- Pre-stain solutions?
- Epoxy Grain Filler- Sand it off or leave a layer??
- durable, hard-use, gold color fill
- Primer and Paint for MDO
- Water based aniline dye.
- Help need w/ tiger maple finish
- Mirror coat Epoxy
- Seal coat-shop made dewaxed shellac vs. Zinsser seal coat?
- Crackle Finish Pics
- Finish For Jigs
- Spray pattern probelm ("tiger striping") with Earlex 5000 spray gun
- what went wrong
- 3M PPC for Fuji G-XPC?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.