View Full Version : Project Finishing
- Fuming White Oak
- Shellac layers
- Masking Tennon or are they tongues
- Best way to remove Watco Teak Oil from Teak Desk
- Recommendations for paint insides of cabinets , Fast Drying
- Finish for Black Walnut table
- Chalkboard Paint?
- APOLLO HVLP power 4 sprayer?
- Restoring knotty pine T&G walls
- First time at the "Finish" line
- Mixol in Clear Poly-Will it work?
- How Does Lacquer Sanding Sealer Differ From Lacquer
- What type of finish?
- Water Rings in EM6000
- Dye and Finish over liming wax?
- Best exterior latex primer
- Please go easy on me. Can I basecoat/clearcoat clean and roughed up stained wood?
- Good Safe Paint Stripper for an item painted with latex paint?
- Finish for dish drying rack
- Endovar vs. Arm-R-Seal
- Sherwood Precat Orange Peel
- mixing red and white oak
- Behlen Rock Hard Waterborne opinions
- Disposing of old shellac
- My Simple, Temporary Spray Booth
- HVLP needle/cup sizing and other details
- Thoughts on Waterlox TrueTone Color-Infused Tung Oi in a Sam Maloof finish?
- HVLP spray gun recommendations
- Sealacell blotch?
- Revisiting poplar
- Sanding Poly to match
- recommendations for teak finishing product for outdoor teak patio furniture?
- Fuji MiniMite 4 or 5 HVLP
- Stripper changes
- Minwax Gel Stain
- I have an old aerisol can of Rustoleum primer
- PPS liners for finish storage?
- Strategy for Enhancing Wood Grain on Rifle Stock
- Switching over
- Another HVLP conversion gun?
- Shellac base coat, help me understand...
- Purple Painter Problem
- Plywood Finishing - De-waxed shellac or Paint Primer
- Any experience or tips with Lockwood oil soluble dye powder?
- GF white poly streaking
- Soaking in acetone?
- Best process to spray a lot of cabinet parts?
- Spraying Enduro clear poly
- Question about spraying Polyurethane with HVLP
- Removing Tung Oil from Grooves?
- Polyurethane Reboot?
- Using a pre-conditioner?
- Replicating Minwax Polyurethane with WB finishes
- Cleaning pine T&G ceiling prior to sealing
- Question about storage of lacquer, acetone, thinner, etc
- School me on airless sprayers..........
- Sealing end grain on large parota cross cut slab
- Arm R Seal extremely cloudy/hazy
- osmo question
- Exterior Chairs and Table Finish Recommendations
- Use MS to "pop" grain w/o damage to wood?
- GF Endo-Var
- Clear TopCoat for water based Modern Masters Metallic paint
- What is happening to my clear finish?
- Painted Top for Kitchen Table
- High humdity: water or oil based top coat?
- Leather dyes for wood???????????/
- Maloofish Finish mistake - too thick.... Suggestions?
- Lap marks on inset top for ring box--any help??
- Bookshelves...What Kind Of Paint?
- Pressure regulator positioning for HVLP guns
- What kind of stain to use under a marine varnish?
- ARM R Seal still cloudy/hazy. Propane heater problem?
- Ebonizing White Oak
- Cypress Table finish
- Oil polyurethane and our lungs
- Table finishing
- Water based dye/stain over sealer top coat?
- Solar-Lux Dye on Walnut
- need help deciding on finish for refinished dining table and coffee table
- VGF craftsman style door refinish schedule
- Refinishing home cabinets - need help
- Paint before or after?
- Amber shellac under WB?
- Behlen Rockhard Waterborne Review
- Best outdoor clear finnish?
- Quality Tung Oil - Satin, finished by hand
- GluBoost products
- Clear Epoxy to fill cracks / knots - Process?
- Common Drawer Finish
- What's your finishing schedule with Target 6000?
- Arm-R- Seal ?
- Paint It Black: My experience with Target EM6600
- Mahogany bench finish choice
- Contractor Ruined Countertops w/ Epoxy - Looking for Help to Fix Them
- Some lessons learned about applying gel stain
- Humidity issues in our new shop
- Water Based Finishes
- Cherry - seal against UV or use an alternative??
- Needs some Finishing Help
- Rub out finish
- Finishing Cherry countertop
- Advice on top coat
- How you get red white blue wood
- Anyone notice a blueish hue using Target EM6000 finish?
- enduro-var over oil stain
- Lacquer problems
- why won't my stain take?
- Paint cabinet doors
- Semi-gloss over gloss?
- Lighten WB stain?
- What did I do wrong
- Top coat on stained wood
- Painting Baltic Birch Plywood
- Finishing Recommendations
- Kitchen island ?
- Filling cracks on a table top
- Waterlox disappointment
- HVLP Sprayer and Latex - Question about
- refinishing Cherry table top .
- Minwax wipe on won't dry
- Lacquer or Shellac
- What do you store home made wipe on varnish in?
- staining maple hardwood floor
- CA glue and baking soda
- Problem wiping off oil/varnish blend
- Finish with least odor for maple
- Odd question about commercial gun stock finishes.
- Turbinair Needles Fit Capspray HVLP Gun?
- Painting new exterior shutters
- Painting oil based paint over water based paint?
- Vinyl decal under or over clear finish?
- first attempt at HVLP finishing
- Maple turning orange from Paduk
- HUGE Problems Using Vinegar / Steel Wool / Tea to make wood look weathered
- ebonizing maple with a white spot
- Fuji Q4 - older system
- Finish Selection for Staircase - Suggestions Needed
- Looking for recommendations: WB Paint for Steel/Iron
- Waterlox finish problems
- Dye & wipe vs spray sealer
- how to finish inside of finger jointed box
- Dying Thick 'Laminates' Question
- Need your advice
- Suggestions on type of finish to use
- finish for Walnut
- Removing mineral oil from wood
- Qualspray Troubleshooting
- Reviving wrinkly Effecto
- What's up with my home made wiping varnish?
- Polyacrylic waterborne finish........OK for interior use????????
- How to repair and refinish these two nightstands?
- Old Old Paint
- Vintage doors
- Repaired /refinished secretary
- Clear Coat On Walnut Turns Whitish
- Sanding between coats of Enduro Var
- Oil Based Poly Urethane Recommendation
- Finish for butcher block - for shop use
- tung oil finish
- Airless or help for spraying latex
- Finish on Cherry side table
- New HVLP tip Worth it for latex? Old Capsrpay cs8000
- pros/cons using rustoleum hammerd paint on a wood cabinet
- Need Help Staining...
- The art of coloring wood
- Matching 1939 old Pine boards - Probably NE heart pine
- Vinegar/steel wool on turned parts
- Looking for a way to smooth out almost-perfect shellac finish
- Exterior Poly Recommendation
- Finishing large live edge slabs
- Can't Decide; urethane, alkyd, acrylic, for interior dog kennel/crate.
- Spraying wipe on poly with a HVLP?
- Handrail: Rattle can Lacquer vs arm-r-seal
- Water poly vs lacquer for table tops
- Epoxy with dye - How deep does it stain the surrounding wood
- Looking for Spray Finisher Options
- Finishing and waxing
- Can I add dye to Rustoleum?
- Butcher block oil finishing is not smooth, help please
- Questions about GF Enduro Var
- Sanding Sealer and Staining
- Epifanes
- Finish Recommended for Beer Flight Holder
- struggling with pore wood filling with shellac
- shelf life of Target Coatings EM6500
- How to clean lacquered wood surface?
- Fuji HVLP Q5 - Gelcoat?
- Dealing With Low VOC Lacquer
- Water Based Stain
- tinted beeswax
- Cigar Ashtray Finish
- Fixing small defect in poly finish
- Finish logistics question
- help with qswo finish
- finishes for projects with kids?
- Problem spraying enduro-var on vertical surface
- GF Milk Paint Help...
- GF Flat Out Flat Poly?
- Removing glue
- Spraying beginner - advice
- General Finishes Conversion Varnish
- Coloring tung oil
- Finishing a Spanish Cedar Adirondack Chair
- Pore filling period furniture
- How to create an oil rubbed bronze finish?
- 1/4" hose adequate?
- MinWax One Coat Polyurethane finish has developed white spots
- Best oil based wood filler that will take stain and match?
- The effect of temperature on fuming
- Purple heart and maple butcher block finish??
- Water based Topcoat over Oil based Stain
- hardwax oil for bookshelf?
- Staining next to inlay
- Aluminum oxide finish
- Cherry wood finishing
- I'm about to test finishing on Spanish cedar.
- Whitewashed Straight Open Grain (White oak?)
- What should I finish trivits with?
- Help with buying a sprayer
- Tinted water based lacquer
- Finishing Pop Up Shelter Needed...
- Timber finish
- Waterlox on bark?
- HELP !!! how to get a glass smooth finish with polyurethane
- Shellac Storage
- Kitchen cabinet paint type
- how to set up many boards repeatedly for finishing
- Gravity Gun Cup Leaking
- Spray Lacquer / brush on lacquer
- Top Coat on BLO....
- Wood Finishing School
- Question: Storing finishes after opening
- dishwasher-proof finish found?
- How to create this finish?
- Fortifying factory finish with more layers of poly?
- Popping the grain on ash
- Danish Oil
- Making Walnut finish
- Topcoat for Milk Paint and distressed wood?
- Refinishing cabinets to freshen up factory laquer finish??
- Railings and banisters
- PPS type cups for gravity gun
- Cedar Chest
- GF Water Based Stains - Using Whitewash to Create Tint?
- Thoughts on Gel Stains?
- Eliminate Through Tenon Signs
- My Experience using Minwax oil based penetrating stain and Varathane wiping stain
- Sourcing anhydrous ammonia
- HVLP Decisions
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.