Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 12:56 PMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: stephen thomas Today, 1:46 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Jerry Bruette Today, 8:27 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Ronald Blue Today, 10:06 PMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Rod Sheridan Today, 8:29 PMHere is a built in I just built (paint grade). So a few things that might help..
1) If you are using a face frame (FF), no one will know
Oilstones should not get clogged or glazed, because the oil keeps the swarf in suspension. Use more oil and you shouldn’t have to lap for years.
Mark Leifer Today, 10:31 PMFrom what I gather, their line of stones are not expensive, but I would be surprised if it didn't work fine.
I have a very similar situation-
Which is what I did and suggested he do. Avoids the issue. Plus and external switch gives a safety factor if you ever have something go wrong you can
Ronald Blue Today, 10:06 PMFunny enough I noticed your website when searching for the planer model number the other day. I was meaning to email you to see if you might have the
Jared Sankovich Today, 10:00 PM
Dining room carver chairs - Take 2
Thread Starter: Derek CohenAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: stephen thomas Today, 3:07 PM