• Recent Polls

    What are your thoughts? (Votes: 6)

    1. Been doing it like (or equivalent) this for years. (Votes: 4)

    2. Wow! Never thought of that. (Votes: 0)

    3. Been doing it with mirrors. (Votes: 2)

    4. Ain't got a boat, truck, care… (Votes: 0)

  • Recent Forum Posts

    Richard Coers

    Router help needed.

    I screw the aluminum to the plywood and run the bearing of a flush trim on the aluminum. Nothing happens to the aluminum. You can always put a layer of

    Richard Coers Today, 12:42 PM Go to last post
    Rafael Herrera

    Abranet Sanding Sheets- Leaving Scrapes & Streaks

    Yes, I see it all the time when I sand metal surfaces, it's more obvious there but the same thing happens on raw wood or finishes.

    Whatever

    Rafael Herrera Today, 12:32 PM Go to last post
    Lee DeRaud

    Paralysis by analysis.....

    A similar thing is where you do something amazing because you don't know ahead of time how hard it's supposed to be.

    I worked on a large

    Lee DeRaud Today, 12:30 PM Go to last post
    Mike King

    Router help needed.

    Not a problem as long as you set the depth of cut appropriately.

    Make sure you've first sized the plywood to slightly larger than the Jessem

    Mike King Today, 12:19 PM Go to last post
    Rich Engelhardt

    Router help needed.

    I have a router plate - actually a Jessem Router Lift II - that I need to use as a template.
    This is sort of in reverse of what's normally done.

    Rich Engelhardt Today, 12:11 PM Go to last post

  • Recent Blog Posts