Had a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Tony Shea Today, 5:28 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Ronald Blue Today, 8:39 AMHow is the Margin Of Error determined for a survey? I don't care who does the survey or what it's for I'm just curious how the margin is determined and who determines it.
Last Post By: Stan Calow Today, 4:46 PMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Rod Sheridan Yesterday, 8:29 PMI just bought an outdoor Pizza oven. It's an Ooni which can burn wood, charcoal or propane. I plan to start with propane as get accustomed to the pizza oven. Eventually, I want to switch to wood at least occasionally. So, like everyone else on this forum, I always have a lot of cut offs in my...
Last Post By: Pat Germain Today, 3:05 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Osage Orange is a bizarre choice for a sound board. That a unique Guitar Body Cittern or Bouzouki. I wonder what it sounds like?
I used it for
Hi, I much prefer the CXS style handle to the more conventional “T” style drill.
Regards, Rod
Thanks, Jim, that seems to be consistent feedback on the CXS model, closer to how we use a handsaw and it aligns your wrist perfectly with the fastener.
Kevin Adams Today, 6:29 PMIt is a very easy to maintain finish. It does not allow mold or microbes to grow in the situations I have used it for. The Turpentine and Pine Tar make
Maurice Mcmurry Today, 6:18 PMI 100% agree with this comment. Hiring a Residential Electrician may not be the best option in this case. I have been in the electrical field my entire
Tony Shea Today, 5:28 PM
Dining room carver chairs - Take 2
Thread Starter: Derek CohenAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 6:12 AM