Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Nicholas Lawrence Today, 8:16 AMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Yesterday, 4:35 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Michael Schuch Yesterday, 11:31 PMWifey said I have to wait until tomorrow before opening the Shaper Origin but I tricked her into allowing me to open the workstation early :) Got the workstation mounted on my Husky toolbox with a raising table so I can do some box joints on 48" long stock, for an upcoming project. I've also...
Last Post By: Michael Burnside Yesterday, 9:16 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I never have used a dewalt router and one of the reasons I suggested the Bosch, other than it being a good tool, is that Dewalt is ownd by the same company
Edward Weber Today, 10:30 AMI hope you don't think I was complaining. I was just trying to let you know I did use them, appreciate what a nice saw the Atkins is, think I know what
Nicholas Lawrence Today, 9:59 AMBefore The world wide web, Lowes, Home Depot, and Payless Cashway there was Sears. Our store was very handy, close by, and open evenings.
The
I believe I have read here that you can buff them after the Tung oil is dry. Not sure about other finishes, sorry.
Peter Blair Today, 9:46 AMIt's situations like this that make learning Fusion 360 a great skill. Not only do you have a system to develop your plans, you can easily change essential
Mike King Today, 9:34 AM
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Mike Wilkins Yesterday, 11:09 PM