Seems like the last decent option for a small bevel gauge at Blue Spruce is no longer available. Previously Vesper was the gold standard but he's no longer accepting orders. I use the Shinwa with the bottom locking screw and it's pretty good. I also ordered the folding Shinwa with the knurled...
Last Post By: steven c newman Today, 5:29 PMI'm looking to build my first set of cabinets in my kitchen. I'm currently building a new house. I am a third generation general contractor so l have a good degree of knowledge in construction my grandfather used to build furniture and cabinets so I have a very good general idea of how they need to...
Last Post By: Maurice Mcmurry Today, 8:26 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Jim Koepke Today, 3:32 PMThinking about the electric lawnmower thread, I decided to put this in a new thread. This out to freak Doug out. I have a 2 acre point on the lake that we are getting ready to be able to rent for weddings. I want to get grass growing on it like Augusta National. To do that, it needs an inch of...
Last Post By: Bill Dufour Today, 4:26 PMHello Everyone, I am new to this forum and was directed here by Joe at Veneer Supplies. My question is in regard to veneering over compound curved shapes, mainly guitar bodies. I am a boutique guitar builder and I am concerned with the longjevity of the flamed and quilted maple supplies as...
Last Post By: Zachary Hoyt Today, 1:14 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Thats excellent Edward and shows why I go for rifts and quarters. Lately I have taken a 2 inch slab, 1 inch each side of the pith, as the first two cuts,
Maurice Mcmurry Today, 8:50 PMThere is a website or two dedicated to selling veneers. I think most of mine has been from Woodworkers Supply and Rockler.
https://winklerwoods.com/collections...erback-veneers
This might help you
From the image you can get a good idea of what cut will do what in terms of likely warp.
Yes. Where is that SMC blog about making raised panel doors with just the table saw? ...
I do not have a shaper and am not likely to buy
I love shapers as much as anyone (currently have 4) but for one set of cabinets that are flat panel and shaker/square profile a shaper is not on my must
Jared Sankovich Today, 8:23 PM
Copyright questions with wood working plans
Thread Starter: dirk martinThere is a person, that has designed very crazy looking squirrel houses. All kinds of fancy, moving parts, and such. He sells the plans to make these squirrel houses in print form, as pdf, and as dxf. He does not sell kits, nor parts. Plans only. Oh his policy page, he writes the following: ...
Last Post By: Ken Fitzgerald Today, 3:46 PM