• Recent Polls

    What are your thoughts? (Votes: 6)

    1. Been doing it like (or equivalent) this for years. (Votes: 4)

    2. Wow! Never thought of that. (Votes: 0)

    3. Been doing it with mirrors. (Votes: 2)

    4. Ain't got a boat, truck, care… (Votes: 0)

  • Recent Forum Posts

    Jim McCue

    Harbor Freight paint shaker

    I have one. I think it says 40-70psi and it sounds and seems slower at 40psi. I think if you go lower than that it gets slower but then it just might

    Jim McCue Today, 10:17 PM Go to last post
    steven c newman

    Lumber supply

    Decided to cut 2 blanks for length over on the Langdon 72c...then joint the edges a bit..

    And get them ready to plough a groove...

    steven c newman Today, 10:11 PM Go to last post
    steven c newman

    Lumber supply

    Trying to "walk it off"...clamps came off the panel for the Top..need to square the ends...

    Guide for the Vintage Skil Home Shop

    steven c newman Today, 10:05 PM Go to last post
    Jonathan Jung

    Dust collection design - 2400sqft shop

    The shop is completely finished, including the ceiling, with drywall. I don't want to hang the ductwork below the ceiling or under a floating floor because

    Jonathan Jung Today, 9:58 PM Go to last post
    Bill George

    Think I may need a new roof, OH boy!

    Have you had any hail or heavy wind damage? That roof should last longer than that. Insurance might cover part of it, If it’s damaged.

    Bill George Today, 9:50 PM Go to last post

  • Recent Blog Posts