Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Derek Cohen Today, 9:08 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 4:27 PMHi all, I don't look often, but when I do it seems there are absolutely no used mortising machines out there. Something I've always wanted (someday) was a knee mill. There's a place near me that has had a Cincinnati Contour Master for sale forever (years and years). They re build these...
Last Post By: johnny means Today, 3:35 PMOne member includes a list of favorite things, one of which is the Oxford Comma. In my early years of education, teachers taught us to use a comma before and in a list of items. In later years, this seemed to drop out of favor. Could it have been the difference due to some teachers having moved...
Last Post By: Alan Rutherford Today, 9:24 PMReplacing my compressor because of a pin hole link in the tank. Many on here state using an auto drain in the tank. My Google searches have provided sketchy results, how does it work and where do I get one? Thanks.
Last Post By: Jimmy Harris Yesterday, 10:19 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
A grass board fence designs big advantage is two fold. Rot from the ground up is contained to one board, easily replaced as needed. The other thing
Bill Dufour Today, 9:41 PMCommon in the SF bay area. Not much used except on older fences here in the valley. reason being is the fence builders assume it is flat here. Older
Bill Dufour Today, 9:27 PMNeither one. ("No" was too short.)
Alan Rutherford Today, 9:24 PMHi Alan
Regarding the question of lighter cuts using a straight pattern bit, it occurred to me later than you could use a step process of
Jimmy, did you record before- and after results?
The mod I added to my Hammer N4400 came from Rob Cosman, and was a simple PVC pipe under
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 2:36 PM