I need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: David Walser Today, 2:40 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 1:24 PMHi, I am back with more questions. Picked up a block plane at the flea market last week. It has no manufacture ID on it. Using EBay for ideas, I found it was similar to a Craftsman and a Winchester 9” block plane with an adjustable mouth. The lateral adjuster is missing and it was rusted to beat...
Last Post By: Rob Luter Today, 6:35 PMHi folks, I am wanting to clean my table saw top. I am going to use a maroon scouring pad with wd40 but want to know what will take the wd40 off so I can wax it. Some videos just say use a degreaser but I was going to use purple power and when I fact checked it stated that it MAY not be good...
Last Post By: Nathan Sampson Yesterday, 9:58 PMI'm looking for a high quality multi-size set of imperial and metric allen wrench bits with 1/4" hex drive. All I can find is cheap junk on amazon, with reports of missing pieces, improper sizes, and fall apart packaging, as well as the small bits snapping off in the screw. Can anyone recommend a...
Last Post By: Brian Holcombe Today, 7:44 AMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
I didn't know this section of the forum is what it is. I saw "design and finished projects" and missed the rest.
My limited experience
Unfortunately, a lot of people will buy 10, use one and try to return the package. Then HD can't sell it because it doesn't have the right number or
Mike Henderson Today, 8:11 PMJust to help you out. I have this dust collector on my Sawstop and it works great. It's really useful when you're ripping. I opted for this instead of
Jay Houghton Today, 8:07 PMYou would think that store layout would be somewhat similar. I have three Home Depots that I shop depending who has what I need (logistics also seem
glenn bradley Today, 8:02 PMI was going to put perforated drainage pipe on the bottom ith a tube inserted in it to water and then a tube towards the top of the pipe as an outlet
Jennifer Duerwald Today, 7:58 PM
The Tips and Tricks Thread
Thread Starter: Ole AndersonOK, let's see if this gets legs. Some time ago I asked (in the Forum Tech Support forum which apparently almost no one reads) if we could have a separate forum dedicated to workshop tips and tricks. Well that didn't go anywhere, so why not just have a thread dedicated to your ideas around the...
Last Post By: Doug Garson Today, 6:53 PM