Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Mike King Today, 11:57 AMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Brian Elfert Today, 8:31 AMThis thread has no redeeming value. You have been warned. Got an ECE block plane here recently. Solely out of curiosity went I looking around, and found LV carries ECE planes, but not this one, but they do have replacement blades for it - which I will never need. Even so - I was pondering...
Last Post By: steven c newman Yesterday, 3:01 PMRegulated season opened yesterday. Trip to Savannah, veered off the interstate to get some
Last Post By: Rich Engelhardt Today, 11:50 AMHi all, I have an older Delta 6" jointer model 37-190 which I've been trying to change the knife blades on (first time doing so). I penetrating oil on the knife bolts but 4 of the screw heads are starting to strip with the 5/16" open end wrench I've been using. I first tried using an 8mm...
Last Post By: mark ahlenius Today, 10:23 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I have a 1/4" 6tpi Supercut on my bandsaw most of the time. It's my general use blade. Not particularly great at anything, but can do most things
Jimmy Harris Today, 12:07 PMThanks, Bruce. I for sure can't lift it up either. But I was able to drag it without much trouble. It's not as full as it will be, but it doesn't seem
Patrick McKenna Today, 12:03 PM Table extension with F-coupling for Felder 01.2.140 | Length 500 mm
That'll handle your support problem. I find it to be an incredibly
The higher the TPI the finer the cut, but you'll also need to consider the density of the material. For general cutting I prefer a 6TPI or higher, but
Michael Burnside Today, 11:51 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Cameron Wood Yesterday, 2:54 PM