I have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Ronald Blue Today, 11:16 PMJust read a post where the guy called himself an epoxy woodworker. Made me think about other combinations; steel woodworker, non ferrous metal woodworker...... Got any other ideas?
Last Post By: Andrew Hughes Today, 11:19 PMThis thread has no redeeming value. You have been warned. Got an ECE block plane here recently. Solely out of curiosity went I looking around, and found LV carries ECE planes, but not this one, but they do have replacement blades for it - which I will never need. Even so - I was pondering...
Last Post By: stephen thomas Today, 9:10 PMI didn't want to kidnap Kent's thread so I started this one. Born in the late '40s, I feel blessed to have lived in the 50s, 60s and 70s to experience the musical buffet of the time. From 50s style country music, the folk music era, the Rockibilly era, Motown, the British Invasion and into 70s...
Last Post By: Warren Lake Today, 7:35 PMHi All, I recently bought the Robust American Beauty. I was hoping the girth and weight of the unit would be enough to keep vibration down but I'm finding it's not. I cored a bowl blank a couple of days ago. I had bandsawed the blank so it wasn't far out of true. The max speed I could get...
Last Post By: Neil Bosdet Today, 10:45 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Too me Epoxy woodworker just doesn’t make sense. It’s like saying vegan barbecue or Electric dragster its definitely possible but just sounds phony.
Andrew Hughes Today, 11:19 PMThey made a holding valve for the Case garden tractors that held back the tractor when adding a tiller for example. They were notorious for "taking
Ronald Blue Today, 11:16 PM1/4 inch shank is fine, just don't make too deep of a pass at once.
I bought some of the woodpecker bits too. haven't had a chance to try them yet.
I had a Shopsmith in the shop for a few years. I stored if for a friend while he was away. The disc sander was a nice feature for certain projects. I
Maurice Mcmurry Today, 10:54 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 1:35 PM