- Spraying water based dye
- Experience with Osmo Oil?
- Pigmented Lacquer vs. Paint (specifically BM Advance)
- PPS for current spray gun
- HVLP question
- Buff danish oil finish before applying poly?
- Finest sanding grit before Arm-R-Seal
- A question about Rubio Monocoat
- Floor finish - Water or oil based?
- Oil/Wax Finish
- Hide Glue Showing Under Tried and True Original
- Question about shellac
- Fuji 5 - orange peel w/ thinned Cabinet Coat and little Floetrol
- refinishing a bed frame
- Wax
- English Elm dining table with Waterlox Urethane finish
- Finish for walnut dining table
- Microfiber Towels
- Correcting for oversanding . . .
- Spray gun setup for finishing wood ceiling
- Fuming White Oak / Ammonia
- Piano Refinishing Issues (Shellac and Nitro Lacquer)
- Conversion Varnish - KemVar Plus for kitchen cabinets?
- Finish for ash stair treads
- Plastic Resin Patio Furniture UV protectant?
- Arm-R-Seal
- Finishing cabinets
- 4 stage or Air Compressor?
- Gloss black (piano finish) on Baltic Birch?
- Stair tread finish suggestions needed, also assembly question
- New Fuji Q4 owner - what finish to spray??
- Stains and finishes for lumber outdoors? NOT preserved wood.
- Guidelines for humidity levels when applying outdoor oil based stains?
- Target Coatings and interior uses
- Burnt wood & Epoxy sign
- Getting rid of wax on table top
- shellac woes
- Tried and True - ain’t!??
- Input needed: EM 8000 CV with crosslinker using Fuji Q4
- Fuji Mini-mite 5 owner - accidentally used an 1.8 needle with a 1.5 nozzle
- Best beginner spray setup
- Polyurethane and oak questions from a beginner
- Target Tinted lacquer
- Repaint Kitchen Cabinet Doors
- Wax Over General Finishes Arm-r-Seal? Does Rubio have a better "feel"
- Finish for Rustic Mantle
- penetrating exterior oil that works?
- Rustins Plastic Coating ??
- Over coating a varnished floor
- Arm r seal
- Bookcase finish ideas?
- Recommendation for a water-based poly that comes in 5 gallon bulk
- oil over sanded poly coated oak?
- Finishing a deck water & oil based
- Free Paint!
- It's been asked before, but can't find a good answer
- Gun cleaner for waterborne?
- Tung Oil over Shellac
- Finishing soft maple
- Allbäck linseed oil paint
- Cedar table top sap issue
- Will paint protect wood from moisture?
- Transtint Dye and Shellac
- Touch-ups on Pigmented WB Lacquer (specifically EM6500)
- Can I still sand in this finishing process
- Refinishing face nailed flooring
- Remote paint pot for pressure-fed gun
- Brush clean up
- Can I wait longer before second coat of oil based poly?
- Fuji HVLP aircap loose
- Shellac bungle
- anyone has used osmo 3051 on oak? (aka looking for a finish to make oak more white)
- Refinishing Restoration Hardware Coffee Table
- Antique ice box
- Classic Dark Pine Trim Recipe?
- DNA Shortage?
- Finish Damage from Hand Lotion
- General finishes high performance - finishing the finish
- Mystery marks on vintage furniture
- Cherry top problem
- Shellac showing under lacquer
- Cherry response to UV over time
- Which Sheen for Cabinet Drawers
- Johnson Paste Wax Alternative
- Strategy for applying Arm-R-Seal to long table with waterfall edge
- Finishes for Pine
- Upgrading HVLP Spray Gun
- Finishing Table with Removable Leg - Finish Separately or Assembled ???
- Spraying HVLP and Humidity Question
- Minwax polyurethane
- Adding color to maple
- HELP! Varathane getting spotty finish
- Color change on a brand new vanity
- Should I wax the details?
- Transtint first timer ?
- Microbubbles or whatever you call them
- Top coat for white oak & brass?
- Water in my DNA - what to do?
- Has anyone fooled with bleach as a wood finish? A scrubbed finish?
- Sapele Finish and Fix Gap?
- Satin finish for speakers
- Help With Target Coatings
- I did a really crappy job of this help?
- Non-yellowing / warming finish for ash T&G walls
- How much is enough bloxigen
- Arm R Seal semi gloss advice
- finishing grandfather clock
- Stain for T&G cedar
- Spraying Enduro Var II
- Painting PVC Trim
- Oddball combinations of woods and stains.
- Brown paper bag & Arm-R-Seal
- Bleaching maple?
- Finishing Koa
- Finishing planed vs sanded surfaces.
- Are two coats of primer needed.?
- Epoxy Sealer (Total Boat)
- DIY Kitchen Cabinet Refinishing - GF new stain doesn't match old
- Can I put a coat of wipe on poly over some brass?
- Outdoor white oak table
- How to paint a large number of childrens blocks?
- Touch up conversion varnish
- Blacktail Nano Finish?
- Who does the best job of matching paint colors?
- Best Clear Target Product For Table Tops
- Stripping Unknown Finish From Tabletop
- BIN Shellac Primer vs Sanding Sealer? Or both?
- I have a couple of projects I'd like to refinish
- Spray Finishing Conversion Varnish - couple questions!
- Finishing Problem
- Has anyone painted Melamine?
- "kid proofing" a dining room table top
- Arm R Seal question
- Walnut coloring due to aging
- Advice Needed - Failed Tung Oil Finish (Splotchy?)
- India Ink - all made equal?
- Help! Advice on filling channel where dado wandered
- Shout out for water-based poly
- Old six board chest
- Walnut end table finishing
- Best finish for a rolling pin
- Mohawk Post Cat Lacquer
- Ben Moore Command - Sheens
- Painting MDF cabinet doors
- Polycrylic Question
- paint for exterior door
- Rubio monocoat smell and feel
- Paint Question
- UV Blocker for a table top finish
- Rubio Monocoat
- Hydrocote
- Finishing plywood edges for bathroom vanity
- How can I fix this?
- Black Walnut
- Std shellac vs dewaxed under top coat finishes
- Endurovar conversion varnish
- Alcohol screwed up my finish
- Knot sealing
- Waterlox adhesion
- Hardwax oil + shellac + water based poly?
- Cherry door veneer repair
- tip: Pizza in the finishing shop
- Alcohol wipedown
- Totalboat Gleam 2.0 on Black Walnut
- Lacquer Question
- Kitchen Table Finish?
- Refinishing A Gunstock
- Deft spray lacquer date code
- Sealing teak
- Walrus Oil?
- Nicest Wood & Finish, small jewelry box
- Sanding sealer under arm r seal
- Touching up a sprayed finish
- Alternates for GF ArmRseal and Enduro clear poly
- Polycrylic cure time for pantry shelf use.
- Paste wax over arm r seal
- Paint Scraper ???
- Podium project finishing questions - please chime in
- Cleaner for Finished Cherry Cabinets?
- Behlen's
- Painting Pre-finished plywood … wacky, I know
- Finishing Schedule
- Gel stain and finish question
- Spraying Lacquer
- Walnut cutting board
- Cabinet/Furniture paint and top coat
- film finish or oil like finish
- Sash Repairs
- When to stop using stripper
- Zinsser clear shellac on cherry
- 3 Stg Turbine HVLP w/ water based Urethane Enamel _ Satin Sheen
- Best low-maintenance finish for outdoor bench
- Bubinga Outdoor Furniture Set
- Pine panel doors, expansion/contraction
- Garage Doors
- Removing wood filler in the future
- Sapele box finish
- Epoxy over deck stain?
- Rattle can nozzles
- Small divot in box
- Apollo Turbine w/ Fuji hose (& gun)
- Convert Fuji M Gun
- Stencil staining of maple
- Finishing issue - light specks in grain
- Shellac padding a bench
- Advice for how to seal two removable tops that set 90 degrees to each other
- Black tongue and groove ceiling
- Easy and quick method to remove varnish that is peeling
- Advice Needed: Choosing Wood Conditioner for pine Board Staining Project
- Removing hot melt glue
- Staining hard maple
- Any transparent oil stains avail in Calif?
- “Skin” over stored Rubio Monocoat
- GF Hi Performance Brush/Foam pad tips?
- how many coats of arm-r-seal
- Farmhouse Exterior Paint Colors?
- Splotchy Walnut HELP?!
- Clearest Target Coatings Product?
- Seeking Suggestions For a One-Part Glue to Replace Epoxy
- Colored Lacquer - primer vs sanding sealer
- Fuming Sapele
- Surface preparation for paint paint over plywood
- Finish Help General Finishes Oil Stain and Gel Stain
- Suggestions on how to recreate something close to this frame stain
- PPG Proluxe Door and Window finish usage
- Light/dry spots on white oak slab
- Micro-mesh versus Mirka Abralon
- Final sanding tool of choice
- I have to paint a dozen sheets of osb
- Splotch appeared when staining
- Grain filling when using Rubio Monocoat
- Watco danish oil on trim in heated and unheated shop walls
- Rubio Monocoat on Kitchen Island
- Help with sanding after staining.
- Finish rec for mesquite
- Sequence question
- New maple flooring has some finish bo boo's
- Help on stain/color tecnique
- Would you refinsih these flooring transition piece of leave well enough alone
- The weight of flat
- Wood Window Frames/Sashes
- White finish for dining table?
- Watco Danish Oil clean or rubio monocoat pure
- Sanding for oil finish- How Far to go
- staining cherry plywood, lines showing up.
- Finish for a Tool Chest
- Reamalgamation of shellac on wood trim?
- ArmRSeal Application
- Walnut, BLO, Shellac, EM8000
- Polishing question