View Full Version : Project Finishing
- How long does it take pre-cat lacquer to cure
- OK To Wait Before Applying Finish?
- Removing polycrylic. Is it possible?
- For those that use the West systems epoxy...
- Thermatru fiberglass front door
- Questions about a spray area
- What air separator do you like for your compressor?
- Tips in buffing out a 2K urethane high gloss finish
- Storing Before Buffing
- Boxwood elder
- Finish for Cherry
- Refinishing "old" dresser
- Which primer for BM Advance (HVLP application)
- Weather protection
- What 'Causes Spray Gun Pulsing?
- How would YOU finish this?
- Advise for finishing inlaid art...
- What solvent for wipe-on varnish?
- Bring out grain on Quartersawn Oak
- Strange question... burning smell from natural gas appliances when using polyurethane
- What top coat for wooden jewelry
- Door refinish gone bad
- metal paint
- Pigmented Lacquer vs BM Advance for built-ins
- Fogiving/non-toxic/durable wipe-on finish - am I asking too much?
- Need troubleshooting help
- How to best finish a large built-in?
- Sprayer Recommendations?
- Finishing Sequence: Sealcoat or Gel Stain first ?
- How long does dewaxed shellac last
- What precautions should I take using finishes in a small basement?
- Minx Polycrylic question
- slow drying acrylic paint
- Surprised - Stain Wouldn't Take???
- Australian Timber Oil - substitute for Boiled lindseed Oil?
- Glue and staining
- Cheap Disposable Paint Brushes?
- Water-based stain/dye
- 3m accuspray
- What's The Name of This Finish?
- Tea Tray... best finish against water and heat?
- Giant Jenga Game .... Finish Issue
- varnish for exterior mahogany door
- Grain Filler Problems
- How should I finish a walnut dresser without oil based products?
- Finishing goncalo alves cooking spoons?
- White furniture: EM6500 or GF Enduro or ????
- Clear finish for Ambrosia Maple?
- WB Finishes -- Seeking Wisdom
- non-darkening finish for redwood?
- Tip: Easy way to dye something jet black
- Behlen Parafin oil
- Pore filling/dye question
- Dust Nibs in pigmented laquer?
- 50 Year old cedar
- Mineral Spirit Coloration
- Varnish finishing
- Odiferous Drawers
- Circa 1850 Woodturner's Jelly...anyone use it?
- Wagner 2900 HVLP
- Finish for Elm live edge slab table
- Confused about wood floor cleaners / oils
- building a spray booth fan
- Enduro-Var
- Water Borne HVLP Convert
- Paint finish for garage storage
- Refinishing a Philco radio cabinet
- Valspar Anti rust Armor clear gloss
- Couple Teak questions - bathroom vanity - color and finish
- Hard finish that can best withstand a ball point pen
- Helping choosing coating to spray on cabinets
- What finish for rough wood shelf/mantle?
- White lacquers?
- Waterborne Polyeurethane Wood Coating
- Advice RE: (near) Top of the Line HVLP Systems
- Stain, Oil, Poly on Reloading Maple Bench?
- HVLP Spray Gun - what to do between coats?
- refinishing an old table, interesting issues.
- LVLP or HVLP spray gun? Help me decide
- How do I protect dyed maple?
- Restoring a live edge
- 116 year old pine flooring - how to finish?
- Glaze and Clear Coat Lacquer, Which One First?
- Fuji mini mite 4 vs. Fuji Q4
- Figure or Blotch
- HVLP Advice Wanted...Needed!
- Fix "hot spot" in new table finish
- Another White Finish Thread
- Wood stain on spheres has a unstainable band around circumference.
- Water based Varathane wood finish over Varathane oil stain - no sealer?
- Where to buy dewaxed Shellac flakes in Canada at a reasonable price
- Timber mate wood filler
- polyurethane and oil
- Finishing Birdseye Maple
- Stripping siekens cetol marine varnish
- Help: Painting Stained Ash Cabinets
- How do I prevent my brush from hardening between coats of shellac?
- Finishing drawers on outdoor furniture
- Finishing for an outdoor table
- Finishing Trial With Birdseye Maple
- Best clear UV resistant varnish/finish?
- Fugi HVLP Guns
- Painting over Shellac Finish
- EM6500 from Target coatings and their cross linker.
- Help with non-functional NEW 3M PPS System
- Having problems with a planed vs sanded surface.
- EnduroVar
- Chatoyance in old furniture: does it decline over time?
- Earlex
- Refinishing a conference table
- A new one for me - opaque finish
- I have ZERO clue as to what to use......
- Finishing the other side
- Stuck on stain color and finishing
- 3 Waterlox questions
- How to remove water stains on stripped tables?
- Excellent lauqer / shellac brushes available for cheap.
- Quick tip: Spray Painting wood
- Finishing Floating Black Walnut Live Edge Shelves
- cover table while curing?
- Rusty spray gun parts
- obtaining finish with water protection
- Walnut
- Staining and finishing solid wood countertop edging
- How to get a smooth finish with high gloss spray paint : wood fuzzy after sanding ?
- How would you finish these?
- WHERE do you spray?
- Help with Alder
- Kraftmaid Cinnamon Stain Match Help
- Bathroom and Kitchen Cabinet Finish Selection - Help Needed
- Refinishing table with grouted-in tile: how to protect grout from stain?
- Stripped table weeps from pores 2 days later
- What finish can I use over Red Mahongany stain?
- Woodlife Coppercoat
- HVLP Recomendations
- Finish for Birch Ply Torsion Box Drawing Board
- How to fill knot holes after finishing
- what dye do you use with your epoxy?
- Antique Maple Finish Matching??
- Mineral Spirits is cloudy? Is this causing problem of poly not drying?
- Fuji spray customer service
- Grey tone finish for red oak?
- Having a problem with front doors of house - Fading stain
- Spray black lacquer looks foggy
- Finishing cherry that will live like a vampire?
- Natural Finish for Quartersawn white oak
- tung oil advice
- Spray gun dribbling at end
- Finish for a maple snow sled
- Paste wax
- Which epoxy
- Mylands cellulose sanding sealer how to thin
- Polyurethane Finish Help
- "Flaking" after finish....?
- Live Edge Table, Unthinned Tung Oil
- Repair Oak Table Finish?
- Spray Finishing 101
- Spray Finishing 101
- BM Advance Topcoating
- water based lacquer
- Liberon "quick drying" Tung oil?
- Old Tung oil getting thick.
- Charles Neil vs General Finish pre-stain?
- Best top coat for bar?
- Shellac
- Target coatings EM6500
- Prefinish?
- Oops.....need advice
- Bathroom/Laundry as a "Finishing Room"
- water trap
- Hard/healthy finish for scratcher
- Shellac Masters: HELP!
- exterior wood sealer
- sealing plywood
- Mineral Oil Question
- What Paint Do You Use?
- Where is all this dust in my finish coming from?!
- Steel Wool
- Arm R Seal Congealed
- Sealcoat under wipe-on poly on walnut?
- can you re-flock if not enough fibers are there?
- Shop Tip: Cleaning shellac brushes
- poly over oil finish
- What Finish Is It??
- Rebuilding and refinishing a cedar chest.
- Lacqure finish
- Mcm sideboard/credenza
- Finish for Birch Cabinet
- Bubbles in lacquer on inside corners
- More WB Pigmented Topcoat Questions
- Waterborne finishes, sealers and veneer
- Will Dried Bleach Still Fade Dye? Need More Contrast.
- Short time lapse movie of finish being applied to coffee table
- Toning Arm-R-Seal Poly
- Spray no wipe (SNW or NGR) stains
- Looking for a "cheat sheet" spraying with a Mini Mite 3
- A simple question about wooden salad servers
- Arm R Seal application tips?
- Advice on finishing live edge Monkey Pod coffee table
- Prepping wood for shellac
- Distressing - lots of small, dark defects
- Laquer Spray - Shelf Life?
- Clear coat suggestions
- Eco Friendly Finishes
- Cedar coloring
- Red Oak Veneered Dining Set Refinishing Project
- How to achieve an aged stain and varnish look.
- Any ML Camp Polarion users out there? Calling all 2k poly buffs.
- Painting Technique Copy
- staining a wooden counter top
- Would an Earlex Sprayport 6002 make sense for what I need to do?
- Failed lacquer finish
- Will Thinned PVA White Glue block Boiled Linseed Oil?
- Stain a lot of fence boards efficiently
- Not a Bar Top but Close ... Best Finish?
- Anyone have much experience with antifreeze as a rot protector / preventer?
- Tiny hairs appearing in polycrylic finish, despite new brush, undisturbed shop, etc.
- Sprayers, which type? HELP
- Another lacquer question
- Machine rubbing - do you prefer ROS or High Speed Buffer?
- Kudos to Mohawk Cosumer Products
- Fixing failed lacquer finish on going saga
- Lowering the Gloss Level, Water Base Lacquer
- How long to let shellac barrier coat dry before staining?
- EMTECH Polycarbonate Urethane on Wood and Oracal vinyl?
- Maple/Walnut combo kitchen island top
- Can a badly-dyed cherry piece be saved?
- Painting dental molding.
- Osmo Polyx Oil - WOW. just WOW!!!!
- Finish for Ash/Cherry C-table
- How long does wood stain stay good?
- Grey tone finish on cherry?
- Meet "Slabzilla"!
- Zar Stain ???
- Sand between finish coats of paint?
- What do you do with your rags???
- Furniture restorers check this guy out
- HVLP Unit Recommondations
- Waterlox bubbles and pitting
- General High Performance Top Coat - Troubleshooting - Help Needed
- How to Manage Squeeze Out After Finishing
- Finishing Makore Veneer
- How do I mute the grain in red oak?
- Need advice on finishing drawer pullouts
- What surface to varnish on?
- any pics of coffee brown transtint on maple
- Help: EM6500 Mud Cracking
- Noob in need of assistance: Water Based Poly
- Finishing Rift Sawn White Oak
- Re-finishing Conversion Varnish
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.