I have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Tom M King Today, 2:57 PMOne of the things I enjoy about wood working is the potential to learn new skills that enhance my over all enjoyment of the craft. As a Neander, often these new skills don't require an extensive investment in new tools. I've been a hand tool wood worker for >40 years and early on everything...
Last Post By: Maurice Mcmurry Yesterday, 8:33 PMHi, I'm new to the forum. I'm 78 and have been using a Craftsman 10 inch 113.298051 for the last 39 years to build furniture for my house and various projects. I never upgraded until now because the craftsman could do what I needed and I didn't want to spend the money. Last week the fence wouldn't...
Last Post By: Gordon Stump Today, 2:58 PMWednesday, the LOML and I will comence traveling through the State of Washington to Vancouver Island BC. Our travels take us through the Tri Cities, Yakima, Mount Vernon, Vancouver Island, Port Angeles, and down to Portland. Does anybody know of sources on that general path where we might find...
Last Post By: John C Bush Yesterday, 9:58 PMThis will be a "build" thread with a bit more detail than I've been doing lately, but it's an interesting project. Some might find it useful; some might scoff. :) But I just can't wait until the end to start posting because it would be too much to post all at once. -------- For background, our...
Last Post By: glenn bradley Today, 2:16 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Hmmm, have NEVER drilled out the waste in a Mortise...I simply lay the mortise out, and then proceed with the mallet and chisel....drilling first just
steven c newman Today, 4:04 PMI'm not old enough to have experienced those acts listed above which is a bummer. I would have loved to see The Doors and Van Morrison back in the early
Pat Germain Today, 4:03 PMSame - about the same time with either method. Drilling + paring is less physical effort than chopping, but I end up with a rectangular hole after a few
Daniel Culotta Today, 4:02 PMThanks for replies, I am indeed looking at the UJK fence that is 90deg to the table, it has a T-track for its own stop and should be tall enough to house
Paul Gilna Today, 3:50 PMYeah, this heat is rough. I'll often weigh whether the cooling effects from the fan aren't offset by the increased cleanup of it blowing sawdust and
Jimmy Harris Today, 3:24 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Yesterday, 5:52 PM