Had a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Dan Friedrichs Today, 4:13 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Brian Elfert Today, 9:49 AMI have a Laguna 14BX 2.5hp 14" bandsaw and a 3/4" Resaw King blade which was bought together with the bandsaw. It works very well and the 3/4" Resaw King blade cut very well although I don't have much experience with bandsaw and don't know how well other bandsaw cut. However, there is always a...
Last Post By: John TenEyck Today, 3:10 PMOne of the things I enjoy about wood working is the potential to learn new skills that enhance my over all enjoyment of the craft. As a Neander, often these new skills don't require an extensive investment in new tools. I've been a hand tool wood worker for >40 years and early on everything...
Last Post By: Ben Ellenberger Today, 3:42 PMAfter last year's trip to this part of the country, a second trip is needed. Total trip recap is in this thread from 2023. https://sawmillcreek.org/showthread.php?301671-Looking-for-some-travel-tips-SC-TN-KY-WV I’m planning this second trip for the fall. I have about 16 days/nights I can be gone...
Last Post By: Michael Drew Today, 2:47 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I used Vix bits to center the holes for the hinges on the box, itself. But on the top, I was afraid to use a Vix bit because the top is so thin - it's
Mike Henderson Today, 4:35 PMGuys, everything you're suggesting has already been discounted higher up in the thread.
The OP checked it wasn't mechanical. The OP checked
My only concern with tool rolls is if they might retain moisture.
Otherwise it is based on what works best for you.
A lot of
This could be the start of a challenge! Try something new and post the results - perfection is not expected.
I just thought of something
I’ve got a couple and think they are nice. They are well made and have good quality canvas. I haven’t put them to heavy use and don’t
Ben Ellenberger Today, 3:38 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 10:02 AM