• Sections

  • Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    andrew whicker

    Milling machine as a mortiser

    Thread Starter: andrew whicker

    Hi all, I don't look often, but when I do it seems there are absolutely no used mortising machines out there. Something I've always wanted (someday) was a knee mill. There's a place near me that has had a Cincinnati Contour Master for sale forever (years and years). They re build these...

    Last Post By: Bob Vaughan Today, 1:58 PM Go to last post
    Zachary Hoyt

    Dumb answers to dumb questions

    Thread Starter: Zachary Hoyt

    I used to feel frustrated when I would have listed something for sale on Craigslist or Facebook and included the town where I lived, and instead of looking it up on their devices people would write to me to ask "where is Orwell" (where I used to live) or now "where is Piercefield?". I finally...

    Last Post By: Patty Hann Yesterday, 11:12 PM Go to last post
    steven c newman

    Lumber supply

    Thread Starter: steven c newman

    Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..

    Last Post By: steven c newman Today, 11:58 AM Go to last post
    Tim Andrews

    Adhesive with a long open time

    Thread Starter: Tim Andrews

    Greetings All, I’ve done a search here, but all the threads I have seen are old. I would like a recommendation for an adhesive with a long open time for complicated glue ups, minimum 30 minutes,. I typically use Titebond 3 but would like more time for some projects. Sometimes it’s possible to do...

    Last Post By: Wes Grass Yesterday, 11:14 PM Go to last post
    Jay Houghton

    Harvey ST-1500 Sliding Table question

    Thread Starter: Jay Houghton

    I recently sold a machine I didn't need and now can repurpose that money into something else. I recently got a Sawstop and was thinking of the Harvey sliding table attachment for it. Expensive but it sure looks like the build quality is first class. You essentially get the Harvey miter gauge as...

    Last Post By: Darrell Bade Yesterday, 11:50 PM Go to last post
    Karl Card

    Grease..... and not the movie....

    Thread Starter: Karl Card

    I have a baldor 7.5HP BALDOR 3450RPM 213T TEFC 1PH MOTOR L3709Ton my table saw. What type of grease should I look for to put grease in the grease or zirk fitting?

    Last Post By: Brian Runau Today, 9:01 AM Go to last post

  • Greg Peterson

    There is no available content written by Greg Peterson