Saw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Stan Calow Today, 9:00 PMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Today, 4:35 PMLooking to upgrade from my old 6" Jet JJ-6cs jointer (which I put a helical head on). I just have a hobby shop for personal use but would like to get an 8" jointer since I find the 6" too small. I've for the most part settled on Grizzly for their affordability and overall good reviews. G0490ZX:...
Last Post By: Warren Lake Today, 10:23 AMWifey said I have to wait until tomorrow before opening the Shaper Origin but I tricked her into allowing me to open the workstation early :) Got the workstation mounted on my Husky toolbox with a raising table so I can do some box joints on 48" long stock, for an upcoming project. I've also...
Last Post By: Michael Burnside Today, 9:16 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Robert M Richardson Today, 8:04 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
As far as I am concerned, a Craftsman router is not worth $12, let alone $120. I swore them off in the late 80s when they started using some kind of polymer
Richard Coers Today, 9:30 PMGreat video, I get to see Joe again in November. He is an amazing talent
Sam Force Today, 9:17 PMAh no problem Ed. I just don't want to display my email nor do I want to display yours. If and when you decide, I've got the files right here for ya,
Michael Burnside Today, 9:16 PMI built a glass top table for my deck about 7 years ago. There is 12 segmented ring around the 3/4" thick glass top. I joined those segments with
John TenEyck Today, 9:08 PMI saw a report on the sand box thing. What it said was some school districts (Colorado?) were considering this as an emergency way to address classroom
Stan Calow Today, 9:00 PM
Lumber supply
Thread Starter: steven c newmanHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 5:04 PM