Due to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Lee Schierer Today, 7:28 AMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Jim Becker Yesterday, 7:11 PMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Tom M King Yesterday, 9:43 PMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Keith Outten Today, 7:27 AMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Yesterday, 6:59 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Between laying the floor and deciding on the tile product, the specs changed from 1/4" thick to 10mm thickness.
Where it would have been easy
I am curious as to why you attribute this trend to the west coast. Poor education in this post-literate society is pretty ubiquitous. I remember having
Stan Calow Today, 8:10 AMI keep a Battery Tender on the start battery on my generator. The battery was made in 2009. Started generator first of the month, on monthly test run.
Bruce Wrenn Today, 8:01 AMMy brothers married sisters. Their father in law had the Motorola dealership in town. The younger brother has been cooking weak batteries with a welder
Maurice Mcmurry Today, 7:58 AMNot a big increase in hp. Will it be enough? If you have to change pulleys and belts you might think about lowering the cutterhead rpm a little, maybe
Tom Bender Today, 7:54 AM
Lumber supply
Thread Starter: steven c newmanHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 7:10 PM