Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 4:51 PMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: stephen thomas Yesterday, 10:45 PMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Lee Schierer Yesterday, 7:28 AMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Ronald Blue Yesterday, 8:14 PMOne member includes a list of favorite things, one of which is the Oxford Comma. In my early years of education, teachers taught us to use a comma before and in a list of items. In later years, this seemed to drop out of favor. Could it have been the difference due to some teachers having moved...
Last Post By: Bill Dufour Yesterday, 10:38 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
First pic is the board sections in the order they were before crosscutting. The next three are the individual boards so you can see grain on the top.
William Lessenberry Today, 12:37 AMI sure can't figure out the problem looking at those photos.
Richard Coers Yesterday, 11:32 PMAmen!
Years ago, after making plenty of tooling, i came to the conclusion that somehow, over mulitple tries, i just did not manage to make
Lot of extra steps there. I would have done it Egyptian style. Made a ramp of stacked firewood and laid the plywood on top. Even make the ramp curved.
Bill Dufour Yesterday, 10:41 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Yesterday, 11:03 AM