Hi all, I don't look often, but when I do it seems there are absolutely no used mortising machines out there. Something I've always wanted (someday) was a knee mill. There's a place near me that has had a Cincinnati Contour Master for sale forever (years and years). They re build these...
Last Post By: Bruce Page Today, 1:20 PMI used to feel frustrated when I would have listed something for sale on Craigslist or Facebook and included the town where I lived, and instead of looking it up on their devices people would write to me to ask "where is Orwell" (where I used to live) or now "where is Piercefield?". I finally...
Last Post By: Patty Hann Yesterday, 11:12 PMThey are going crazy building standalone car washes in my area. I know of at least three currently under construction nearby, and a few others that recently opened. Car washes are going up all over the Minneapolis metro area. There will easily be three times as many standalone car washes once...
Last Post By: Cameron Wood Yesterday, 2:37 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 11:58 AMGreetings All, I’ve done a search here, but all the threads I have seen are old. I would like a recommendation for an adhesive with a long open time for complicated glue ups, minimum 30 minutes,. I typically use Titebond 3 but would like more time for some projects. Sometimes it’s possible to do...
Last Post By: Wes Grass Yesterday, 11:14 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
My Logan mill uses R8 collets. That, and every Bridgeport I have ever run (dozens of them) that used R8 collets required a tap on the drawbar to break
Bruce Page Today, 1:20 PMThanks, I'll have a look and see if they have a solution.
Doug Garson Today, 1:09 PMNot sure an air to air heat exchanger would be applicable in my case. Air to air heat exchangers recover heat from exhaust air to heat incoming air
Doug Garson Today, 1:05 PMAFAIK you have to make your own nut cage etc to make it a self ejecting drawbar. R8 tends to fall out on its own. Most other milling taper sare much
Bill Dufour Today, 1:01 PMI'm one who has never had a good experience with TimberWolf blades. I never found them to be particularly sharp, which then required more feed pressure,
Edward Weber Today, 12:05 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Koepke Yesterday, 3:25 PM