Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 7:10 PMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Lee Schierer Today, 7:28 AMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Bert McMahan Today, 12:24 PMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Bill George Today, 9:51 AMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Keith Outten Today, 7:27 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
That's good...here, they have only had some forms of "knock off" connectors. I ended up buying off Amazon when I needed them for the shop build.
Jim Becker Today, 1:43 PMI've come to learn over the years that sometimes travel time is just part of the cost of getting the right material for the project...and the right material
Jim Becker Today, 1:42 PMAny chance your planer isn't set with the cutter head level to the table? You could be planing a taper across the width of the board.
Jerry Bruette Today, 1:37 PMYou can make the pieces long as possible, ripped square. Then hold them together, flip and repeat. Having a helper , helps.
Mel Fulks Today, 1:34 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 11:03 AM