Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 8:20 PMSaw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Warren Lake Today, 11:58 AMI am looking for what people in other jurisdictions have dealt with. I have always understood that, in my city, fences between homes were the responsibility of the homeowner who first puts it up. And the rule was "good side out" and 6" off the property line. But after a discussion with a...
Last Post By: Brian Elfert Today, 9:16 AMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Ray Selinger Today, 11:51 AMAll - Has anyone seen or used the Harvey COMPASS RG-1/RG-2 Universal roller guides. They look solid and would be a pretty useful addition to my shop, but the price seems way too high. I'd love to hear any feedback. Thanks.
Last Post By: Lloyd McKinlay Today, 12:46 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
In California the #1 lane is the high speed lane. Pull into #2 if someone is coming up on your tail. get more then five? cars behind you and pull over
Bill Dufour Today, 11:58 AMtransmissions should be manual. 12,000 cars were stolen in toronto by punk ass kids in 2023. Most of them can use a computer and steal your car in 1
Warren Lake Today, 11:58 AMThanks Bryan, great tip to plane the jointed face to make sure they're co-planar. I do get a better surface off the planer than the jointer for sure.
Adam Daniel Today, 11:57 AMI doubt if the local lumber yard marks materials up 100%. There would be more lumber yards around if they made that kind of profit. There are also middlemen.
Richard Coers Today, 11:57 AMA band saw uses guides for their thin blades. I use graphite impregnated phenol board for my old Beaver band saw. Old saw mills used litne vitea pucks
Ray Selinger Today, 11:51 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 5:25 PM