Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 7:10 PMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Bert McMahan Today, 9:30 PMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Tom M King Today, 9:43 PMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Jim Becker Today, 7:11 PMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Jim Becker Today, 1:18 PMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Today, 6:59 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Three passes with a beading bit in a router table should do it.
Cameron Wood Today, 9:47 PMNo apologies needed. It's always an interesting problem to solve and not as much work when it belongs to someone else. I'd still like to know how the
Tom M King Today, 9:43 PMNo but keeping NOCO trickle chargers on the ones that don't get used much makes them last longer than those size batteries ever have before. In fact,
Tom M King Today, 9:41 PMRead about another scam... a local one (for me).
Problem is AZ has no Toll Roads. Not one.
Jim, if you’re referring to this from my account “My three favorite things are the Oxford comma, irony and missed opportunities” I have no strong
Michael Weber Today, 9:35 PM
vBulletin Message