View Full Version : Project Finishing
- Sanded through finish
- process for acrylic painting of relief carving, not a decoy
- Staining Hard Maple vs Soft Maple
- advice on Fuji Q3 or Q4
- Best all natural sealant for indoor furniture (pallet bed frame)
- White paint/finish for poplar furniture?
- Ideas for finishing my walnut and maple table
- Getting rid of dust nibs while maintaing gloss - How do I do it?
- OK. Here's a new way to screw up a finish (with assistance, in my defense)
- Waterborne acrylic vs lacquer solids content?
- Product to remove lacquer finish?
- Spraying White Lacquer on Bookshelves and Plantation Shutters
- what finish for project painted white?
- dye on curly cherry?
- Varnish Brush
- my $.02 on the finishing roller coaster
- Getting out Abralon 2000 swirl marks from final finish
- Aqueous Ammonia supplier for fuming
- Spraying latex
- Good finish for trivets
- Shellac on tung oil ?
- Pratt Lambert #38
- Sam maloof's finish
- Grain popping walnut
- Finishing A Child's Footstool
- Finish unexposed edge of MDF-core veneer plywood
- Finishing fishing lures -
- Looking for advice/suggestions on finishes and application there of.....
- Cabinet-Finishing Damsel in Distress! Need Help!
- source of micro mesh hook and loop
- Questions about preparation and use of Arm-R-Seal Oil & Urethane Topcoat
- Water-based lacquer over wipe on poly
- spar marine varnish finishing
- Backing out of BLO
- Waterlox Original Sealer vs. Daly's Seafin Teak Oil
- Achieving cross ventilation in cold weather?
- Is Japan Color resistant to fading?
- Finishing Dilema HELP!!!!
- Shellac
- How to remove pre-applied oil from wood to get it to accept yellow glue
- Need tough table finish that can go over a decal
- Sanding coats of Waterlox on Walnut
- Polyurethane
- Retarder for MLCampbell Post Cat
- Old Poly or Varnish
- bleach small areas of gray spalt in soft maple
- Watco Butcher Block finish
- Target coatings EM9000
- Red Oak Table Top
- What did I do wrong?
- Finish for bird's eye maple veneer, for guitar top
- Final sanding of varnish
- Tips on eliminating air bubbles, specifically tung oil?
- Inexpensive gun to pair with an Apolllo system?
- Wormy Bark on Redwood Burl - Epoxy?
- Please Critique My Rifle Stock Finishing Plan
- Shellac on tung oil or tung oil on shellac?
- Thoughts and Questions On Staining Methods
- Finish for dining table...
- Am I finishing this cabinet the best way?
- Finishing maple
- What type of clear coat for a high gloss "piano finish"?
- Finish for wood kitchen island
- What is better for a kitchen table top
- Walnut Restaurant table tops
- Refinishing bleached out oak kitchen cabinets
- Having issue matching a stain
- Qualalac satin drying gloss
- Exterior Finish
- Do I need a certain kind of spray gun with this sprayer? campbell hausfeld
- Finishing Problem
- waxing pine?
- Tung oil particulate settling out?
- How Often Do You Clean Your Spray Gun?
- Question about Waterlox for butcherblock countertop
- Finishing edge grain oak conference table?
- Home Shop Spray Shellac?
- Osmo in a HVLP?
- Zinsser Seal coat shelf life
- Steam resistant finish repair
- Stabilizing Cedar Knife Scales
- Gloss streaks when rubbing out finish
- Finishing Black Walnut slab with bark on live edge - Noob
- Varnish
- CrystaLac Clear Gloss
- Finishing walnut beer bottles
- Using soybean oil in custom mixed wiping oil/varnish
- Should I use a little oil when apply shellac?
- Finish for Maple kitchen cabinets
- Seal with varnish instead of shellac: Any reason this won't work?
- Filling the gap between painted floor boards - Real World Suggestions Please
- General High Performance Polyurethane Problem
- Shellac from flakes help please
- Inexpensive home still, for making ethanol?
- Finish for padauk
- Poly Wipe Marks on Desktop
- Strip paint from MDO
- Waterlox final step (paper bag)
- How to fill in chip out
- Workbench finish recommendations
- Canned Spraying in tight spots? PLEASE HELP
- Red elm finishing
- What is wipe on poly ?
- Price per sq ft for finishing with high gloss piano finish, buffed
- sanding on the last layer of polyurethan varnish.
- End Grain Table
- cutting board finish
- Thought on an affordable HVLP system
- Filling the grain after a few coats of varnish
- Suddenly very worried I've bitten off more than I can chew!!! Finishing cabinets!
- Red oak pore filling question
- Tinting Shellac?
- Paint sprayer for a novice?
- Water based top coats for kitchen cabinets
- Another question on what clear finish for bathroom vanity
- Your favorite polishing compound?
- Tips for first time user of Shellac as finish for shadow box project
- Timber framing finishing
- Water based exterior stain on pressure treated lumber
- Target EM 1000 Sealer Questions
- emulating teak
- Aged oak, blackened oak
- Finish for Bread Bowl
- A Question for the Finishing Experts
- Blotching - face grain vs quarter sawn
- Exterior Door Finish
- Live edge walnut
- transtint vs transfast?
- How to refinish an Ulmia workbench
- Red Oak Table Top - Stain Issues
- Spraying shellac
- Finish a project
- Best non-yellowing water based poly
- Soft Maple finishing with Tung oil
- Need HVLP finishing advice!
- Final Buff Out for Dining Table Finish?
- Shellac Rubbing Out Problems
- BT&C Shellac, from Woodcraft?
- Fast finishing help needed!
- Isopropyl alcohol
- Cabinet shop switching to waterborne
- Redwood Slab Blotching
- build a Sheen with shellac.
- Spray Ventilation
- Finishing Advice: Finishing Maple as "Espresso"
- General Professoinal Finishes vs Retail Products
- Trying to match maple handrail
- waterlox, questions remain
- Sanding sealer question
- Tung oil coats intervals/thinning
- Other HVLP systems (Capspray & Croix)
- finish for interior of a cherry chest of drawers
- Buffing out a dining room table top
- Linseed oil
- Proper disposal of dirty paint thinner
- Removing excess dried tung oil (i.e. "frost")
- Looking for tips on Waterlox Original Sealer/ Finish
- Need advice on finishing ziricote
- Where does the color go
- Veritas Adirondack Chairs
- Spraying wet mil, dry mil drying time
- finishing front door
- blotchy shellac on pine slab
- Baby Safe for a crib
- Airbrush, a perfect tool for making repairs to finishes
- Finishing Question
- Spraying BM Advance or Satin Impervo
- detect wax on wood surface
- Refinish mahogany deck myself?
- Evening out the color in this plywood board
- Restoring old church bench/pew
- Painting treated wood
- Protect soft maple - abrasion resistance
- How to safely removing heavy wax build up?
- Top Coat For BLO Treated Beech Desktop
- How Much Shellac?
- Uneven staining in mystery hardwood
- Deck stain as general purpose interior stain ?
- Garden Arbor
- Acrylic Impregnated, Acrylic 2K Urethane, Epoxy, Waterlox, or Oil for Oak Flooring?
- Top vs bottom cup (pressure feed) gun
- Painter Pyradmids
- Shop Cabinet of Maple - Anyone Know where to buy...?
- Masking Tape
- Pool table refinish
- What's Going On at Homestead Finishing
- Wagner Home Decor Paint Sprayer?
- Lacquer Questions
- Natural Edge Walnut Bar Top
- Knotty pine finish?
- "Groovy" ply?
- Live edge Mesquite dining table
- Thinning poly/stain mix
- Whoops too orange. A Lockwood dye question
- Lacquer vs varnish vs spar varnish - looking for good "primer" on when to use what!
- Wipe/Brush on Clear Satin Finish for Pale Baltic Birch Ply Cabinet?
- Ipe furniture
- Any suggestions on a bad walnut table leg?
- Cherry-ish stain for Douglas Fir?
- Time to learn how to fill with epoxy....
- Penofin
- Sanding scratches
- What grain filler do you prefer?
- Black Walnut Crib Finish
- Figuring out BioShield oil finishes
- How to get this color stain
- Varnish worn off my table?
- Spray advice
- Best finish for a patio table
- Teach me about Spray guns
- Does Waterlox Original Finish/Sealer "even out" when it cures?
- Festool Surfix - Comments/Experience anyone?
- Repairing a pure tung oil finish
- How to recreate this
- Help with dye, shellac, poly trouble
- Using EM6500 from Target Coatings
- Hardest finish needed for table legs to prevent damage by nibbling pet Rabbit
- Minwax Spar Urethane question
- Advice on tacky Arm R Seal
- Clear Filler,Spackle, or Caulk?
- EnduroVar Alternatives?
- How to finish Purpleheart? and restore color after sanding?
- Darkening Cherry
- Recipe for Garnett Ultraseal?
- Help - Wife wants me to put a finish on painted kitchen cabs
- Does BLO go bad?
- Hiding Oak Plugs on Danish Furniture
- Gloss clear coat on painted surface
- White oil finish for white oak
- Exterior Finish Recommendations
- Stain color help
- Best finish for barnwood wall?
- Finish for (alchoholic) drink rails
- Spraying Kitchen Cabinets
- Need Help Salvaging a Bad Stain Job
- Asking for advice on finish for bathroom cabinet doors
- French Polishing problem- pumice stays white in walnut
- Dye staining curly or figured maple for 2 tone grain
- Newbie Question about laquer finishes
- Finish Removal and Glue Strength
- Bloxygen?
- Problems with Endurovar
- Platina Shellac - Excellent quality & good price.
- Finishing of an Oak Bar in Basement
- Poplar and paint?
- Arm-R-Seal over GF Gel Stain NOT DRYING! HELP!
- Sanding sealer
- Iron acetate can also take out the reds that might throw off your stain color
- Best option? Signing/numbering cherry humidor.
- Different shellac for different wood?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.