Well after I had been away from my CNC for a while I went out to run a file but needed to surface my table. The problem I had before reared it's ugly head again. It would start to run then one of the steppers would start to stutter some times it was the X1 then the X2. I ended up sending the controller back to Gary to have a breakout board put in and some adjusting. I have been trying to get it to run but it just won't. I have been working on this problem now for over a week and still have yet to run a file. Gary offered to take it back and I think I will take him up on that but. I am going to be out over $100 just in shipping fee not to mention 3 bits. Gary told me that my steppers are to old to run but they do run fine with my old Shopbot controller with Gecko drives I just have to have one of my boards gone over as the Y is acting up but I ended up moving that to the A drive for now.