• David Buchhauser's Avatar
    01-17-2021, 4:05 AM
    I have been using a small 3d printer for several months now for prototyping and making useful parts. The most recent parts I made were some...
    19 replies | 547 view(s)
  • David Buchhauser's Avatar
    01-04-2021, 2:41 AM
    I can't open this one either. Here is the error message. Also you are using trial version 10, and I have version 9.5. Older versions apparently...
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-03-2021, 11:13 PM
    Hi Vince, I am not able to open files from the trail version of VCarve Pro. So all I have to go by is your Mary jpeg. Here is my manual trace. ...
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-03-2021, 9:22 PM
    Hi Vince, Are you using the "Trace Bitmap" command here, or are you manually tracing? Perhaps you could post the jpeg/bitmap file your are importing...
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-03-2021, 2:03 AM
    Vince - here are the resulting dxf files from the "trace bitmap" operations above. David
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-03-2021, 1:51 AM
    Vince - here are the resulting dxf files from the "trace bitmap" operations above. David
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-03-2021, 1:37 AM
    Hi Vince, Turning down the resolution on the scan will not help. You never said what your end goal is with Joseph. Is this simply to learn how to...
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-02-2021, 2:44 AM
    I use Inkscape quite often for auto-tracing of bitmap images. In general, I use a combination of Paint.net, Inkscape, and Design Edge (in that...
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-02-2021, 2:30 AM
    Hi Vince, The bitmap from the scan of your hand tracing with pen would probably take many hours of node editing to clean up as a usable vector file....
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-01-2021, 4:12 PM
    Hi Mark, I have downloaded your file and it does indeed have the usual problems from a hand trace. I will get back later today with a clean file and...
    30 replies | 1494 view(s)
  • David Buchhauser's Avatar
    01-01-2021, 5:24 AM
    If you traced with a pen, then your tracing line width is probably so wide that both sides of the lines are being vectorized. You could probably...
    30 replies | 1494 view(s)
No More Results
About David Buchhauser

Basic Information

About David Buchhauser
Location:
Tucson, Arizona
Interests:
Metal Fabrication/shaping, Automotive restoration
Occupation:
Mechanical/Electrical Engineer

Statistics


Total Posts
Total Posts
874
Posts Per Day
0.64
General Information
Last Activity
Today 3:21 AM
Join Date
04-21-2017

1 Friend

  1. John McGovern John McGovern is offline

    Member

    John McGovern
Showing Friends 1 to 1 of 1