OK so I'm engraving a License plate one just finished and I put in another one, same file just hit start again. it starts to run but 5 min's in the gantry just stops but the laser is still firing. I hit stop it goes back to the beginning and I hit start again and the job starts to run again but about 2 mins in the gantry stops again but the laser still firing. I hit stop and this time nothing happens, I hit esc nothing happens, so I turn off the laser and restart it. I notice in the panel the place were it normally says Laser is blank. So I'm thinking somehow it lost the file it was running. So I reloaded the file and the panel came up the way its suppose to. But I haven't tried to run the job again. For one I want to see if anyone might know whats going on and 2 I have to get another license plate since I ruin the last one I had.