Had a break on my Grizzly 0766 that I never expected..Got done turning the outside of a future bowl and went to remove the face plate from the spindle..Had the pin threaded in the way I have many times,wrapped my arms around the wooden piece put some weight on it to pop it loose and then this happened..I have the pin but the broken casting part is somewhere in the shavings under the lathe..I will sift through it later..I'm pretty sure I can still use the lathe,but how do I go about getting this replaced or repaired..Bought it 3-4-16 is something like this covered by Grizzly?? Any input is appreciated..Thanks for your time..