How do you guys cut small wood parts - for lamps and the like?
I have a old Unisaw with the overarm guard - However, the way the guard is made you have to flip it back out the the way if you can pieces smaller than about 2" wide.
I don't like doing that but sometimes i have to cut something a bit narrower.
If I start trying to make lamps those pieces are often a lot narrower than 2".
I was thinking I could flip the blade guard back and try one of those MICRO-JIG GRR Rippers - they are suppose to be able to cut down to as small as 1/4" x 1/4".
Any suggestions or thoughts on the GRR Ripper - GR200?