As yall may recognize, I am an inquiring type. I like to know the ins-outs of everything I can. This is another of those things....
What are yall's thoughts on power vs speed?
I mean, is it better to run 100mm/s at 100% power or go for 50mm/s at 50% (those are fictitious settings, purely hypothetical and assuming both would cut clean through)? I don;t have the experience yet to know which is better. Or are they the same as far as the material being cut goes? Does running lower power extend the life of the tube? And if so, substantially or only a little? I mean is it worth it to make a cut take longer at a lower power or speed it up and use higher power to get it done faster?
Also, anyone know if running slower with less power will produce more or less charring on materials such as wood?