...with the new trotec s300. Have been doing some practice work on wood, thought I'd attach one pic here.
This was a tiff of an MCEsher print, "ripples in water". I have always been a big fan of his work, and it looked like a lot of his work translates well to halftone laser engraving. In trotec job control process options, this was done under relief setting, 500 dpi, floyd steinberg dithering, 100% power, 85 speed, 500hz.
Anyone know much about the different choices in dithering found in trotecs print setting page? I notice there are different choices for 'halftone' settings in the pull down box, such as 'ordered dithering', 'stuckey', 'jarvis', 'floyd steinberg', etc.. What setting do you tend to use for halftone relief engraving?
Really enjoying this new tool!
edit* added original print
ripples3.jpg EscherRippledSurfaceLR (1).jpg