Hi all,
Apologies if this is a common solution...to a common problem!
When I got my Grizzly 8" jointer, I needed to align the motor and cutter head pulleys. But there was a piece of the cabinet in the way, and I could not see the edges of the pulleys, or run a straight edge across them.
I came up with this simple idea that worked really well. Used a Forstner bit to drill a hole larger in diameter than the obstruction, and the band saw to cut a slot the width of the diameter of the hole.
Pulley alignment then became a simple task...
Too much to do...Not enough time...life is too short!