Xenetech laser issue

**Andrew Mammoliti** · 05-04-2011, 4:23 PM

Ok, having a issue were text is shifted to the right on all plates, when suppose to be centered. If the same text is vectored it's fine, but when going to raster mode and also the larger the text the more it's shifted to the right. ie: 1 inch text is shifted over 3/4" or more. belts are clean and pulleys too?

Thanks Andrew

**Mike Null** · 05-05-2011, 5:24 AM

Andrew

Can you tell us a little more? What software are you using? Did you, by chance, set the job up as paragraph text?

**Andrew Mammoliti** · 05-05-2011, 7:31 AM

Xenetech software, I have been on the phone with the tech. And they can't get it either! I am thinking it's software related. As vector is fine!

**rich santana** · 05-10-2011, 10:10 PM

my xenetech guru says 'select all and then ungroup'.
try that.

**Andrew Mammoliti** · 05-11-2011, 10:55 AM

Hi Rich, it's little more complicated than that. ;-)

Thread: Xenetech laser issue

Thread Tools

Rate This Thread

Display

Xenetech laser issue

Posting Permissions