The target was to create mitred panels for two cases, which would form the basis for two night stands ...



And then they needed to me rebated at the rear ...



Finishing up with all these ...



Time to tape together ...



And glue up ..



We ended here ..



Today I made a template for the bow fronts, marked the curves , and used the bandsaw to remove most of the waste ...



I contemplated cleaning this up with spokeshaves, then came to my senses and used a trim router and flush trim bearing ...





And cleaned up with a HNT Gordon spokeshave ...



All the trouble at the start to make the mitres as clean and tight as possible. How did we do?



The rebates and mitres look good ...



And I like the bow fronts ...

Tight mitres too




Regards from Perth

Derek