Quote Originally Posted by derek labian View Post
Ok, well I tried to lift it up, at least laying down, I guess I'm not one of those two "stout" men. I'm going to have to build that gantry.
Interestingly, the back side of this saw is not flat, its angled. I assume that it's some kind of design ascetic however it makes it very hard to just "lift up" since it constantly wants to roll to one side and fall over. There is only one lifting hook. Luckily I unpacked the middle of the saw, found a damaged bell housing, and the manual. The manual simply says lift it by the off-center hook at the top of the frame. :/