I'm going to be making a 3' x 6' oval conference table with a leg design similar to this:
2019-11-17_08h48_21.jpg

Wondering about your suggestions for the leg joint I have boxed in red. I'm worried about the lateral movement of the bottom legs at the floor - the top of the upper legs will be attached to the top so no movement there. My initial thought is to cut the upper and lower legs out of a board wide enough to afford me the material to do a full ship lap joint - lots of glue surface and there will be a section of each leg that is vertical. I don't like the block at the center where the legs join, so need to get rid of that as well. And I would like to avoid seeing any bolts or fasteners. All suggestions welcome.