new computer...went from a Win7 to the Win10,,,,learning about photos....hope I have the sizes about right.

Ran most of the Ash scraps through the saw, today,,,3-4" wide, then resaw to about 3/8" or so thickness...
resaw set up.JPG
Something like this. blade can't reach to the half way point...
box sides.JPG
So, I had to run each pair through at the bandsaw, to split them apart...
long slats.JPG
These longer ones weren't quite as scary to run through...
part of the clean up in the shop, was to tear down the Stanley 45, and give it a good cleaning,,,even the threads on the bolts. A dab of oil on each bolt, before I packed things away...had even found a couple cutters under the rest of the cutters.
packed up.JPG
All shined up, and ready to go. Cutters will get a hone, right before I use them. Screwdrivers?
screwdrivers.JPG
That round ball of a handle is from Millers Falls...tiny Rosewood and brass one is a Goodell-Pratt...I think you can id the rest. Square handle one and the G-P are perfect for doing the spurs. I did go out and buy a new sander...as the B&D one is trying to throw a bearing..
new sander.JPG
Thinking all those thin boards can be made into a box, or three? Looks like I need to get a plane out, and flatten a few parts..
resaws.JPG
And figure out what size to cross cut this to....
Stay tuned..