OK, you know I am a LMM-6038 fan & VERY unhappy it's no longer available. Seriously you had to try pretty hard to mess up a job using 6038. It would work no matter how thin or thick. Even runs weren't much of an issue. Currently, I'm stuck using LMM-14 - very touchy or the old LMM-6000 - not very versatile.
So anyway, I decided to try their LMM-6060 replacement... First sample, I diluted with DNA - It wanted to separate like oil & water. I reduced the dilution until it worked, but was then too thick (engraved badly). So, I then tried another sample, diluting this time with water. Looked good... at first, but still separated before it could dry (water dries many times slower than DNA). Did I just get screwed with a bad batch or has anyone else had issues with 6060? I'm going to keep experimenting.
Did I mention I miss the 6038 formula?