Here is a challenge for the Trotec community.
I am running a job that is 6" x 18" Both Raster and Vector on the plate. Designed in Corel X6.
The Vector portion of the plate is spot on in all respects. The raster labels are off in alignment starting from the center to the outside lettering on both sides... other wise the center label at 9" is good, the remaining labels to the left and right creep off alignment.
Ran a test: Vector cut (red) an 1" x 18" rectangle and measured......it was 1" x 18".....
Ran same test: Raster engraved (black) an 1" x 18" rectangle and measured......it was 1" x 17.688".....
Any thoughts,
.
Reply With Quote