Results 1 to 10 of 10

Thread: Edge straightener? Jointer-ish thing for the table saw.

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 06-27-2020, 11:12 AM #1
    Malcolm Schweizer's Avatar
    Malcolm Schweizer
    Malcolm Schweizer is offline [OP] Contributor
    Join Date
    Jun 2013
    Location
    Neither here nor there
    Posts
    3,846
    Blog Entries
    6
    That makes sense. I am going to do this for the shop where I teach, which doesn’t have a very good miter slot on the outfeed.
    Reply With Quote Reply With Quote
  3. 06-27-2020, 4:41 PM #2
    Malcolm Schweizer's Avatar
    Malcolm Schweizer
    Malcolm Schweizer is offline [OP] Contributor
    Join Date
    Jun 2013
    Location
    Neither here nor there
    Posts
    3,846
    Blog Entries
    6
    600 board feet of mahogany to clean up and this is working very well.
    C19D1AEF-5BF0-4C68-908E-D8AC3845D597.jpg
    Reply With Quote Reply With Quote
  4. 06-27-2020, 4:52 PM #3
    Bruce Page's Avatar
    Bruce Page
    Bruce Page is offline Moderator
    Join Date
    Feb 2003
    Location
    In the foothills of the NM Sandia Mountains
    Posts
    16,661
    I was forced to improvise when I had to sell my jointer to make room for my cnc.
    Here’s my version. I wouldn’t want to do 600 bf on it but for onesie-twosie, it works pretty well.
    Attached Images Attached Images
    Please help support the Creek.


    "The older I get, the better I used to be."
    Lee Trevino
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules