Hi,
Like the post heading says, I'm looking for a topcoat recommendation for an Alder kitchen table, 54" round that will likely see lots of wear and tear. I'm planning on aniline dye followed by shellac followed by wiped on glaze. The question is what to put on top. I can spray HVLP and would prefer to work with a water based finish but I do not like the look of WB Poly for this particular project.
Any fans of GF Enduro Var? If so would this be a good application for it? And would I need a vinyl sealer or any kind of sealer over the glaze, before the topcoat?
If I cannot get what I want in water based, then I was thinking a pre-cat Lacquer might be the next logical choice and any recommendations there would be great.
Or if I'm going in the wrong direction and should consider a completely different route, do tell.
Thanks
Edwin