Saw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Doug Garson Today, 9:30 PMLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Patty Hann Today, 7:46 PMHi all, I have a Laguna Cflux-3 that was giving me some intermittent issues turning the unit on and would take a few hits of the switch or remote control 'on' to get it to start up. Today, the motor won't start at all. I do get a 'beep' coming from the circuit board when turning it on and the...
Last Post By: Robert Hayward Today, 11:00 PMHI! I am new here and new to the combination machine world... Regardless I have the opportunity to purchase a 1999 BF 631 for a ridiculously low price. It does come with some issues that I need to mentally resolve before pulling the trigger. Felder considers this an "old" machine and thus...
Last Post By: steven sivak Today, 9:24 PMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: Rafael Herrera Today, 9:05 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Good to hear. I am guessing also that a loose terminal is what caused the burn.
Robert Hayward Today, 11:00 PMI saw your post and just bought this cheap $40 monitor. I fel like this cheap one is inaccurate. The read in my garage is very low, sometimes the reading
Eugene Lee Today, 10:52 PMI bake my own bread and like even slices. So I made a 3 sided wooden holder with a a slot for the knife near the end of both sides. Then just advance
John Ziebron Today, 10:48 PMI want to add a big like to Bill Howatt's posts.
There is also a retention method for MT that includes a flange and a threaded nut, so it
im pretty sure when I saw those past you tubes they said they didnt know how fast it could go. They said this is the speed but there is still more. I
Warren Lake Today, 10:38 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 6:38 PM