If you’re using a mobile browser, sending a PM is very clunky. Switch to the “full site” (bottom middle) and PM’s are easier - tap on the person’s name and an option to PM them comes up.
If you’re using a mobile browser, sending a PM is very clunky. Switch to the “full site” (bottom middle) and PM’s are easier - tap on the person’s name and an option to PM them comes up.
Gabe, JR has the manual you need. Mine is for the non-pneumatic version. You can also get a copy by calling SCMI parts.
I realized that I had forgotten about this thread, and since it has popped up again: I did away with cartridge filters after blowing a few up due to back pressure from a non-optimal cyclone allowing blow-by. The collector unit that I have now has a pretty high inlet velocity and an oversized baghouse. A lot of the sanding dust spins out in the cyclone. The filter fabric is Beane (R). It has loop fabric inside and smooth outsides, and the filtration and cake release are very good. The collector dedicated to my widebelt also has this type of filter fabric. I use a Dylos particle counter and the air quality with the collectors in use is good.
JR
Good to know. Thanks. And thanks all for being so helpful. This just forum is such a wealth of knowledge.
Bought mine recently for about $750 USD.. one small problem. it doesnt have the fence!!
Its an older model, an Unilev 15m, but I am guessing its the same part as the newer Unilev 150????
thumbnail_image001.jpg