• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Jerome Stanek

    Glowforge release

    Thread Starter: Jerome Stanek

    I was wondering if Glowforge has sent out any units yet. I thought they were supposed to release the middle of December.

    Last Post By: Matt McCoy Yesterday, 12:19 PM Go to last post
    Theo Hall

    Calling all owners of Lie-Nielsen Scraping Planes; 212 112 85

    Thread Starter: Theo Hall

    Hello all, I was given a 212 Scraping plane from a very kind family member for Christmas. I must be doing something wrong however, as the only shavings I am currently getting are either so rough, they are like a blunt plane iron would give you (complete with dreaded tearout), or just dust, like...

    Last Post By: Patrick Chase Yesterday, 5:01 PM Go to last post
    steven c newman

    Step back cupboard, a build thread

    Thread Starter: steven c newman

    Time to get busy. hauled two planks to the shop, tonight. Mr. Gumption picks some strange times to show up...;) Marked the first one, in order to get two blanks out of it. Second one only had enough for one blank.....got out a saw.. A D-112, and that big, old square. Was only trying...

    Last Post By: steven c newman Yesterday, 6:45 PM Go to last post
    Brandon SPEAKS

    dovetail saw

    Thread Starter: Brandon SPEAKS

    So I know there are other threads on dovetail saws, but this might be a slightly more specific question. I intended to buy a Veritas standard dovetail saw but woodcraft was sold out so I figured no big deal I will wait a bit. But they are still sold out, so I looked online and nothing on amazon,...

    Last Post By: Pete Taran Yesterday, 11:37 AM Go to last post
    mark mcfarlane

    Fixing a glue up gap?

    Thread Starter: mark mcfarlane

    I'm making couple of end tables out of white oak. I didn't have any 8/4 in stock for legs so I tried gluing up some 4/4 to make 8/4. I have done this successfully in the past using red oak,... Two of my eight legs have a slight gap between the boards as per the picture below which shows the...

    Last Post By: Simon MacGowen Yesterday, 8:44 PM Go to last post
    Jim Becker

    In-shop Location Space Question for CNC

    Thread Starter: Jim Becker

    Part of the decision process for bringing a CNC machine into my shop is physically locating it. Camaster has provided a "prepping" guide for one of the configurations I'm considering and they recommend what is certainly universally ideal suggestion that there be a minimum of 36" inches of access on...

    Last Post By: Jim Becker Yesterday, 1:18 PM Go to last post
  • Matt Day

    There is no available content written by Matt Day