Confetti Lights

[Ed Scolforo]

Here's a few lights I did, two from maple (mine really DID crack easily) and one from mesquite that I bought from Curtis when visiting San Antonio last Thanksgiving. One thing I found out is that you need a drill bit bigger than 1 1/2". I think 40 MM might be just right. 1 5/8 may be a tad too loose?
Ed

[Mark Pruitt]

The one forefront and center is my favorite. Beautiful wood and very nice job!

[John Miliunas]

Nice looking lamps, Ed! As for size of the hole, I couldn't exactly tell you, as I hog the receiving holes out with conventional turning tools. And you know, I'm not even exactly sure why I like doing it that way better!

[Jim Becker]

Front and center is certainly my favorite on these...but they are all very nice! I think that for a small object like this, burls and other really figured stock make for a great project. And you can get a lot of mileage from your burl stock, both in general and in use of off-cuts, etc. I think that this is why the one in front really jumps out at me...in addition to the form.

[JOHN VITOSKY]

Yea I turn the inside instead of drilling it also. It seems to add to the truning of the project when it is completely turned. But to each his own

[Paul Engle]

they look great Ed, iI use a 1.5 " drill and clean it up with a skew to exact fit. too many drills too many decisions ...

[Keith Burns]

Very nice lamps ED. I too like the mesquite best I would like to see the cracked one as well

[Rusty Smith]

Ed, very nice work. What size blank did you start with and what are the finished dimentions?

[Mike Vickery]

Very nice I like the center and left the best.

[Bob Noles]

Nice job, Ed!

I really hope to try some of those one day, they intrigue me.

[Ed Scolforo]

Ed, very nice work. What size blank did you start with and what are the finished dimentions?

Thanks to all for your comments. The pictures did not do them justice.The larger ones were about 4.5x 4.5x 3.5" high. They finished at 4x3.25". The mesquite was smaller, finishing at 3.5 x 2.25"high. It's a good way to use pieces too small for bowls/vases. I agree, burl or other figured wood is best.
Ed

[John Hart]

I like them all Ed. Very handsome group of pieces!

[Steve Schlumpf]

Very nice work Ed! Really like the mesquite!

[Jim Ketron]

Nice job Ed!
The 1 5/8" is a tad larger than the lamps but will allow for wood movement.

[Bernie Weishapl]

Those are beauties Ed. Love the mesquite one.