So here's where I announce that I screwed up
... I stand corrected about the drivers concerning the machine itself, after doing some more research online and on my computers, I found that Yes indeed the control board DOES require a driver, and I apologize for the mistake. Part of the reason is that the newer EzCad versions are 'full-auto', first time you plug in the machine the drivers load and you're done forever. The older EzCad versions and/or controllers SHOULD auto-load, but not sure on that. And when searching my devices, I didn't see the machine on the list. Well, it is, on all 3 computers, at the very TOP of the list, duh.
fbdvr.jpg
oops....
moving on
-- I just tried attaching a zip file of my machine's drivers to try--
And I notice you added a post while I'm writing this-- 2.5.3 is my Triumph's version, which may help.
Anyway, my files are too large to upload here so I need to put them on my server and link to them, which will take me a few minutes
below is a link to the machine driver folder, click to download it, copy it 'my documents' where you can find it easily-- in a perfect world, turn on the machine and the computer should recognize the machine, look for the driver, find it and load it automatically--
DriverAllInOne.zip
If that doesn't happen and it lets you browse for a driver, navigate to the 'drivers' folder, and JCZLMC.inf is the driver setup file, and should work. Hopefully...
IF it loads the drivers, and you DO have a 'non-dog' card like the info says, the machine should work with the 2.5.3 version of EzCad.
I'll check back later, jobs to do are calling my name!